Influence of Filler Alloy Composition and Process Parameters on the Intermetallic Layer Thickness in Single-Sided Cold Metal Transfer Welding of Aluminum-Steel Blanks

Abstract

Hybrid components made of aluminum alloys and high-strength steels are typically used in automotive lightweight applications. Dissimilar joining of these materials is quite challenging; however, it is mandatory in order to produce multimaterial car body structures. Since especially welding of tailored blanks is of utmost interest, single-sided Cold Metal Transfer butt welding of thin sheets of aluminum alloy EN AW 6014 T4 and galvanized dual-phase steel HCT 450 X + ZE 75/75 was experimentally investigated in this study. The influence of different filler alloy compositions and welding process parameters on the thickness of the intermetallic layer, which forms between the weld seam and the steel sheet, was studied. The microstructures of the weld seam and of the intermetallic layer were characterized using conventional optical light microscopy and scanning electron microscopy. The results reveal that increasing the heat input and decreasing the cooling intensity tend to increase the layer thickness. The silicon content of the filler alloy has the strongest influence on the thickness of the intermetallic layer, whereas the magnesium and scandium contents of the filler alloy influence the cracking tendency. The layer thickness is not uniform and shows spatial variations along the bonding interface. The thinnest intermetallic layer (mean thickness < 4 lm) is obtained using the silicon-rich filler Al-3Si-1Mn, but the layer is more than twice as thick when different low-silicon fillers are used.

Characterization of Influences of Steel-Aluminum Dissimilar Joints with Intermediate Zinc Layer

“…Additionally, it is essential to identify the original composition of the zinc layers on the steel and aluminum, as well as the original phases. The conditions of diffusion and phase formation may be influenced by the presence of small amounts of silicon or eutectic MgZn-phases in the zinc-magnesium layer on the steel sheet [39,40]. For this purpose, further measurements are currently being carried out using EDX and XRD analysis.…”

The Optimization of FDM 3D Printer’s Structure Based on Finite Element Analysis

“…In general, the principle of mechanical structure optimization is to improve the natural frequency of the mechanical structure and avoid the occurrence of frequency coupling [14,15]. According to the analysis of the above finite element, in the discussion of the optimization of the printer's structure, the structure of the 3D printer can be divided into the entire nozzle system and the remaining part of the rack.…”

Investigation and Analysis of Mechanical Platform Optimization for MEM Type 3D Printer

“…), aluminum alloy (beam, fixed frame), copper alloy (nozzle, heating wire), PMMA (hopper, support between hopper and the polarization motor). According to the literature [4,5,6], the main material properties as shown in Table 1 Contact surface type setting and grid optimization. The contact types in finite element software ANSYS is divided into the fixed contact, non-separation contact, non-friction contact, and friction contact [7,8,9,16].…”