Influence of High–Temperature Oxidation on the Strength of Ceramics Based on ZrB2

Vedel, D. V.; Grigoriev, O. N.; Osipov, A.E.; Mazur, Piotr

doi:10.1007/s11003-022-00593-y

Cited by 1 publication

(1 citation statement)

References 37 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Alumina (Al 2 O 3 ), as a typical ceramic material, not only possesses high hardness, strength, and stability [1][2][3] but also exhibits excellent thermal, optical, and electromagnetic properties [4][5][6]. It is now widely used in industrial, medical, chemical, and aerospace fields [7][8][9].…”

Section: Introductionmentioning

confidence: 99%

Vat Photopolymerization of Ceramic Parts: Effects of Carbon Fiber Additives on Microstructure and Mechanical Performance

Wang,

Wu,

Guo

et al. 2024

Materials

View full text Add to dashboard Cite

Vat photopolymerization (VPP), as an additive manufacturing (AM) technology, can conveniently produce ceramic parts with high resolution and excellent surface quality. However, due to the inherent brittleness and low toughness of ceramic materials, manufacturing defect-free ceramic parts remains a challenge. Many researchers have attempted to use carbon fibers as additives to enhance the performance of ceramic parts, but these methods are mostly applied in processes like fused deposition modeling and hot pressing. To date, no one has applied them to VPP-based AM technology. This is mainly because the black carbon fibers reduce laser penetration, making it difficult to cure the ceramic slurry and thus challenging to produce qualified ceramic parts. To address this issue, our study has strictly controlled the amount of carbon fibers by incorporating trace amounts of carbon fiber powder into the original ceramic slurry with the aim to investigate the impact of these additions on the performance of ceramic parts. In this study, ceramic slurries with three different carbon fiber contents (0 wt.%, 0.1 wt.%, 0.2 wt.%, and 0.3 wt.%) were used for additive manufacturing. A detailed comparative analysis of the microstructure, physical properties, and mechanical performance of the parts was conducted. The experimental results indicate that the 3D-printed alumina parts with added carbon fibers show varying degrees of improvement in multiple performance parameters. Notably, the samples prepared with 0.2 wt.% carbon fiber content exhibited the most significant performance enhancements.

show abstract