Influence of machining parameters on surface roughness in finish cut of WEDM

Han, Fuzhu; Jiang, Jun; Yu, Dingwen

doi:10.1007/s00170-006-0629-9

Cited by 114 publications

(46 citation statements)

References 7 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…Also, short duration with high peak current value can be suggested for better surface roughness. It was determined that surface roughness can be improved considerably on using reverse polarity machining with proper pulse energy [31].S.S. Mahapatraet.…”

Section: Literature Reviewmentioning

confidence: 99%

“Research Work for Optimization and Effect of WEDM Cutting Process Parameters on Performance Measures- a Literature Review”

Kumar¹

2017

IJRASET

View full text Add to dashboard Cite

Section: Literature Reviewmentioning

confidence: 99%

“Research Work for Optimization and Effect of WEDM Cutting Process Parameters on Performance Measures- a Literature Review”

Kumar¹

2017

IJRASET

View full text Add to dashboard Cite

“…It is experimentally identified that with the increase in discharge energy either by increasing voltage or capacitance, R a increased in die sinking EDM, wire EDM (WEDM) and WEDG (Uhlmann et al, 2005;Han et al, 2006;Chiang, 2007). A large discharging energy usually causes violent sparks and results a deeper erosion crater on the surface.…”

Section: Surface Roughnessmentioning

confidence: 99%

Micro Eletro Discharge Milling for Microfabrication

Ali¹,

Mehfuz²,

Khan³

et al. 2012

Micromachining Techniques for Fabrication of Micro and Nano Structures

View full text Add to dashboard Cite

“…The analyzed results have a good agreement with testing results. In another study (Fuzhu et al 2007), the influence of machining parameters on surface roughness was investigated experimentally in WEDM. It was found that surface roughness can be improved by decreasing both pulse duration and discharge current.…”

Section: Literature Reviewmentioning

confidence: 99%