Influences of TIG welding parameters on tensile and impact behaviour of aluminium alloy joints: A Review

Thakur, Yashwant

doi:10.9790/1684-15010020254-58

Cited by 5 publications

(2 citation statements)

References 3 publications

(6 reference statements)

Supporting

Mentioning

Contrasting

Order By: Relevance

“…TIG welding may be automated to boost productivity because of its high level of accuracy [1][2][3]. TIG welding can weld a variety of materials with varying degrees of success by using a V or U notch to boost the specimen's hardness.…”

Section: Introductionmentioning

confidence: 99%

To Investigate the Weld Bead Hardness at Various Current through TIG Welding

Tiwari¹,

Verma²

2022

JFSA

View full text Add to dashboard Cite

In the industrial industry, TIG welding is the most frequent method of putting metals together. The electrode is held at a 10°–15° angle to the vertical by the welder while he initiates the weld by striking an arc and creating a puddle. By moving the electrode and arc in tandem, the welder "pushes" the molten metal forward and toward weld. welder strength of a building is determined by the quality of its weld beads. The weld's mechanical qualities are mostly enhanced by the weld's quality. The writers of this article explain how to weld with high weld bead quality by using the proper welding parameters. In this research, it has been proven that the hardness of welded joints improves with the increase in welding current up to 110 A for 6 mm thick plates, and afterwards declines with the rise in welding current. Splash and damage to the workpiece could occur when the current is raised to an excessively high level. Because the workpiece is so thin, high current might cause the material gap to grow. This practise may result in an increased weld affected area and a longer time to deposit the same amount of filler material, as well as damage from high heat. Inverted microscopic analysis of the weld zone was performed in order to assess the effect of the welding parameters on the weld quality. As part of the TIG weld bead quality improvement process, dye penetration testing is performed.

show abstract

Section: Introductionmentioning

confidence: 99%

To Investigate the Weld Bead Hardness at Various Current through TIG Welding

Tiwari¹,

Verma²

2022

JFSA

View full text Add to dashboard Cite

show abstract

“…By proper welding and different welding parameters welding defects can be controlled. A comparative outcome between TIG welding and base material can be investigated using Tensile, Impact test and investigation of Microstructure at different zones of the weldment [3]. Furthermore, it was observed that a failure at welded zone over the welded specimen after conducting tensile test.…”

Section: Introductionmentioning

confidence: 99%

An Enhancement of Properties on Al7075 and Al6061 Dissimilar Materials Welded by TIG Process

S¹,

Godwin²

2020

IRJASH

View full text Add to dashboard Cite

Aluminium alloy was a predominant metal among alloys elements. The aluminum alloys like Al7075 and Al6061 which has the major elements of Zn, Mg, Cu, Si with which it will improve the hard-brittle crystalline structure and conductivity. To enhance the properties of dissimilar joint metal, TIG (Tungsten Inert Gas) welding is propagated. Mechanical properties like Tensile, Impact, Bending, micro-hardness and the study about microstructure analysis were carried out. As a result, the energy absorbed by the dissimilar joint metal is 16J and the hardness of dissimilar joint metal is 51.3HV.It revealed that, there is a high impact strength and micro-hardness properties. Consequently, the microstructure (HAZ) image exhibits good bonding strength and sufficient plastic deformation was improved due to fine distribution of grains.

show abstract