Investigation of Microhardness and Microstructure of AZ31 Alloy after High‐Pressure Torsion

This chapter reviews the thermal stability of ultra-fine grained (UFG) microstructure in selected magnesium and titanium-based materials prepared by severe plastic deformation (SPD). The focus is on the wide palette of experimental methods applicable for investigation of microstructural stability. These methods include scanning electron microscopy (SEM), electron backscatter diffraction (EBSD), microhardness measurement, positron annihilation spectroscopy (PAS), and electrical resistance measurement. Microstructural stability of UFG commercially pure (CP) Ti and Ti-6Al-7Nb alloy produced by equalchannel angular pressing (ECAP) is studied ex situ after annealing by SEM, by microhardness measurements, and in situ during heating, by high precision electrical resistance measurements. Both materials show stable UFG structure up to 440°C. Further annealing causes recovery and recrystallization of the microstructure. At 650°C, the microstructure is completely recrystallized. Magnesium alloy AZ31 is prepared by hot extrusion followed by ECAP. UFG microstructure recovers and continuously recrystallizes during annealing. The microstructure of UFG AZ31 alloy is stable up to 170°C and subsequent grain growth is analyzed. Special attention is paid to interpret the activation energy of the grain growth. The superplastic properties of UFG AZ31 alloy are investigated in the temperature range of 170-250°C.

show abstract

Investigation of Microhardness and Microstructure of AZ31 Alloy after High‐Pressure Torsion

Cited by 2 publications

References 30 publications

Mechanical properties and microstructure evolution in ultrafine-grained AZ31 alloy processed by severe plastic deformation

Mechanical properties and microstructure evolution in ultrafine-grained AZ31 alloy processed by severe plastic deformation

Thermal Stability of Ultra-Fine Grained Microstructure in Mg and Ti Alloys

Contact Info

Product

Resources

About