Investigation of SU-8 as protection layer for prism SPR sensor towards reusable honey adulteration detection

Jaafar, M. B.; Hasnan, Megat Muhammad Ikhsan Megat; Othman, M. B.; Nayan, Nafarizal; Azman, Zulkifli; Yaacob, Maslina; Zin, Rosnah Mohd

doi:10.1109/sennano51750.2021.9642662

Cited by 1 publication

(1 citation statement)

References 13 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…An alternative approach of using the surface plasmon resonance (SPR) technique was proposed. Since the SPR sensors were discovered, the technique has been applied to the detection of bacteria [14,15] and coronavirus [16], the detection of adulteration of honey [17,18] and milky [19][20][21] and measuring the quality of food [22]. In addition, SPR sensors were applied to measure heavy metal ions in the water [4,[23][24][25][26][27][28].…”

Section: Introductionmentioning

confidence: 99%

Analytical Design of a Portable Surface Plasmon Resonance Sensor by Using a Divergence Beam for Measuring Multiple Heavy Metals and Other Contamination Simultaneously

Hossea,

Rugumira

2024

East Afr. j. eng.

View full text Add to dashboard Cite

The study proposes a surface plasmon resonance (SPR) sensor for measuring water quality by detecting the presence of heavy metal ions and other contamination. The proposed SPR sensor operates in the Kretschmann configuration, which employs the divergence beam produced by the Powell lens. The beam is diverged to eliminate mechanical scanning, indicating that the sensor can measure water quality from deionized water (DIW) with refractive index (RI) of 1.3317, diluted DIW with multiple heavy metal ion such as Hg[II], Pb[II], Ni[II], Zn[II], Cu[II] at concentration of 100 μM and other pollutant with the RI of 1.34 without any mechanical movement. The proposed SPR sensor has a theoretical sensitivity of 399.45˚/RIU and resolution of 1.3456×10-8 and 8.3790×10-10RIU with 8-bits (ATmega1284) and 12-bits (STM32F401RE) ADC of the controller, respectively. The CCD sensor (TCD1304AP) and microcontroller data sheets were used to calculate the theoretical in which all these components are very chip. The reported sensitivity and resolution were achieved because of the proper application and optimization of TiO2 and BaTiO3. In comparison to a conventional SPR sensor, the proposed SPR improved sensitivity and figure of merits by 50.98 % and 13.93 %, respectively. Furthermore, the proposed SPR sensor outperforms recently published research in terms of performance

show abstract