Investigation of the Effect of Welding Residual Stress on Natural Frequencies, Experimental and Numerical Study

Gharehbaghi, Hussain; Hosseini, Shahram; Hosseini, Rezvan

doi:10.1007/s40997-022-00588-9

Cited by 3 publications

(1 citation statement)

References 31 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Abdelmoula et al [2] analyzed the vibration characteristics of AA6061-T6 aluminum alloy friction stir welded plates through finite element simulation and found that the existence of residual stress indeed affects the natural frequencies of the welded plates. Gharehbaghi et al [3] analyzed the impact of residual stress on natural frequencies of 6061-T6 aluminum alloy argon arc welded plates through a combination of modal testing and finite element analysis. Gao et al [4] have begun to study the impact of welding residual stress on natural frequencies at an early stage.…”

Section: Introductionmentioning

confidence: 99%

Numerical Simulation of Residual Stresses and Structural Vibration of Welding Repaired Blades

Zhang,

Luo,

Liang

2024

J. Phys.: Conf. Ser.

View full text Add to dashboard Cite

Taking a typical aero-engine high-pressure compressor blade as the research object, the Gauss heat source was used to numerically simulate the repair process of blade surfacing welding. The temperature data and stress data of the blade were obtained when the heat source velocity was 1 mm/s, 2 mm/s, and 4 mm/s, respectively. The results showed that both the temperature and stress values decreased with the heat source velocity increasing. Then, the residual stress of the repaired blade is introduced into the modal analysis module as prestress, and the Campbell diagram is drawn to analyze the natural frequency and speed margin of the blade respectively. The results show that as the heat source speed increases, the frequencies of each order of the blade decrease. The speed margin of each resonance point is greater than 10%, and the modal dynamic stress corresponding to the resonance speed can be used as the primary criterion for blade failure.

show abstract

Section: Introductionmentioning

confidence: 99%