Investigation of the natural ventilation of wind catchers with different geometries in arid region houses

Abstract

The wind catcher or wind tower is a natural ventilation technique that has been employed in the Middle East region and still until nowadays. The present paper aims to study the effect of the one-sided position of a wind catcher device against the ventilated space or building geometry and its natural ventilation performance. Four models based on the traditional design of a one-sided wind catcher are studied and compared. The study is achieved under the climatic conditions of the South-west of Algeria (arid region). The obtained results showed that the front and Takhtabush’s models were able to create the maximum pressure difference (ΔP) between the windward and leeward of the tower-house system. Internal airflow velocities increased with the increase of wind speed in all studied models. For example, at Vwind = 2 m/s, the internal flow velocities were 1.7, 1.8, 1.3, and 2.5 m/s for model 1, 2, 3, and 4, respectively. However, at Vwind = 6 m/s, the internal flow velocities were 5.6, 5.5, 2.5, and 7 m/s for model 1, 2, 3, and 4, respectively. The higher internal airflow velocities are given by Takhtabush, traditional, front and middle tower models, respectively, with a reduction rate between the tower outlet and occupied space by 72, 42, 36, and 33% for the middle tower, Takhtabush, traditional tower, and the front model tower, respectively. This reduction is due to the due to internal flow resistance. The third part of the study investigates the effect of window (exist opening) position on the opposite wall. The upper, middle and lower window positions are studied and compared. The air stagnation or recirculation zone inside the ventilated space reduced from 55% with the lower window to 46% for the middle window and reached 35% for the upper window position. The Front and Takhtabush models for the one-sided wind catcher with an upper window position are highly recommended for the wind-driven natural ventilation in residential houses that are located in arid regions.

Factors affecting on human thermal comfort inside the kitchen area of railway pantry car - a review

“…The result already states that increasing the volume of the exhaust hood will reduce the dissatisfaction rate of the occupants. Few researchers suggested the natural ventilation or air supply system and solar chimney for improving the thermal environment in hot and humid regions [109][110][111]. Accordingly, some researchers guided the optimization modeling such as "heating and cooling" systems for better thermal comfort conditions, which helps to save energy consumption [112][113][114][115][116].…”

Evaluation of summer thermal comfort using in situ measurement and dynamic simulation, hot and arid climate in Algerian Saharan region as a case study

“…Several researches show that recourse to local resources and intelligent designs, by integrating passive devices and effici t operation can considerably reduce the energy demand [4,5]. Among them, the research on natural ventilation techniques in hot climate, using various typologies of wind sensors in hot and arid zones; carried out by Energy Laboratory (ENARGARID) at the University of Bechar in Algeria, with cooperation of the unit of research on materials and renewable energies [6]. In the same context, another published study concerned the potential of heat exchangers techniques, system earth-air (EHAHE), used to guarantee interior comfort in hot and cold seasons [7].…”

Natural convection between hot and cold cylinders in enclosed space filled with copper-water nanofluid

“…This natural mode has many technical embodiments. Indeed, it can be encountered in heat exchangers, cooling towers, cooling the minuscule devices of electronic systems, metallurgies, marine engineering applications, solar collectors, air conditioning systems and so on [1][2][3][4]. Therefore, it is necessary to clarify the thermal behavior of such frameworks by determining their relative controlling parameters in order to boost the heat transfer rate of these systems.…”