Investigation of Variation in Stress Concentration Factor with the Change in Orientation of Central Hole on a Rectangular Plate

Pandey, Manish; Patel, Aprajita; Jaiswal, Kshitiz; Kirola, Lalit; Sharma, Subodh Kumar

doi:10.1007/978-981-15-8704-7_77

Cited by 1 publication

(1 citation statement)

References 9 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Results show that Von Mises stress is inversely proportional to corner radius to opening to width ratio and stresses can be reduced with reinforcement. It's necessary to put the long length of openings hole was parallel to the direction of the load, to minimize SCF [47,58,59]. A Santos et al have determined SCF in combined discontinuities fillet and groove in flat plates using the FEA and analyzed there were no vital variations between the theoretical knowledge and obtained data through simulation.…”

Section: According To Types Of Discontinuitiesmentioning

confidence: 99%

Effect of various discontinuities present in a plate on stress concentration: a review

Patel

2022

Eng. Res. Express

View full text Add to dashboard Cite

The stress concentration factor is one of the most significant factors in design engineering in the modern era with lots of objectives across the world. Stress concentration is the localization of high stresses primarily due to discontinuities within the time, abrupt changes in cross-section, and contact with stresses. This paper focuses on a problem with different discontinuities as specially holes present in a plate like isotropic, anisotropic and orthotropic etc. The different methods used by various authors to evaluate stress concentration with different related parameters, and describe the study related to the results carried out by them. Finite plate with polygonal, circular, inclined circular, and elliptical types holes has been considered one of the most important design applications in the present era. In the present work, the analysis and reviews are based on the following (a) types of discontinuities, (b) types of loading, (c) material/Composites/Plies (d) orientation of discontinuities in a finite plate. Finally, the scope of this research work is incorporated.

show abstract

Section: According To Types Of Discontinuitiesmentioning

confidence: 99%

Effect of various discontinuities present in a plate on stress concentration: a review

Patel

2022

Eng. Res. Express

View full text Add to dashboard Cite

show abstract

Investigation of Variation in Stress Concentration Factor with the Change in Orientation of Central Hole on a Rectangular Plate

Cited by 1 publication

References 9 publications

Effect of various discontinuities present in a plate on stress concentration: a review

Effect of various discontinuities present in a plate on stress concentration: a review

Contact Info

Product

Resources

About