In
this study, porous Ag-xerogel (Ag-Xero), Ag-faujasite (Ag-FAU)
zeolite, and Ag-mordenite (Ag-MOR) zeolite sorbents were loaded with
iodine gas [I2(g)] under saturated conditions at 150 °C
for 24 h, followed by densification and consolidation into monolithic
waste forms using spark plasma sintering (SPS). For Ag-Xero materials,
SPS pellets were made with as-loaded samples, while others were made
with preheated (PH; 500 °C for 2 h) samples to help with densification.
SPS processing was conducted at 50 MPa under different temperatures
(T = 200–800 °C) for different times
(t = 0.5–30 min), where eleven AgI-Xero samples,
five AgI-FAU, and two AgI-MOR separate samples were produced. The
primary goal was to look for the optimum processing parameters for
each material to yield pellets with high iodine retentions, high densities,
and low porosities while preventing AgI decomposition. The Ag-Xero
showed the highest iodine loadings (q
e = 470 mg g–1) compared to Ag-FAU (q
e = 368 mg g–1) and Ag-MOR (q
e = 108 mg g–1). Measured
iodine concentrations were the highest in AgI-Xero pellets without
PH, followed by AgI-Xero with PH, AgI-FAU, and then AgI-MOR. Silver
utilization (I/Ag on a mol % basis) values were in the order of AgI-MOR
≈ AgI-Xero (no PH) > AgI-Xero (PH) > AgI-FAU. Chemical
durabilities
of SPS-densified AgI-Xero (PH) pellets were very favorable, with lower
releases than SPS pellets made from AgI-Xero samples without PH. These
results show promise for iodine waste form production.