Linear enslavement of dc bus voltage of hybrid system wind-photovoltaic

Arezki, Saliha; Boudour, Mohamed

doi:10.1109/efea.2012.6294029

Cited by 3 publications

(3 citation statements)

References 2 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The single-phase H-bridge inverter circuit includes four switching components, such as MOSFETs, IGBTs, etc. [18].…”

Section: Electronic Circuit and Controllermentioning

confidence: 99%

Design and Performance Investigation of a Series Compensated Inductive Wireless Power Transfer System for Supplying a Low Power DC Load

Buyuk

2024

Bitlis Eren Üniversitesi Fen Bilimleri Dergisi

View full text Add to dashboard Cite

In this study, a series compensated WPT system is presented for low power DC load applications. Series LC resonant circuits are applied for both transmitter and receiver sides of WPT system to reduce the impedance at a specified operation frequency, and thus, ensure low power losses. The operation frequency is chosen as 109 kHz for the series compensated WPT system. Then, the series resonant LC filter is designed according to the operation frequency and WPT rating values. In addition, the power electronics systems with their controller and operation principle are demonstrated in depth. To investigate the performance of the proposed system, a 100 W series compensated WPT model is designed and constructed in Matlab/Simulink enviroment. Different simulation results are provided to illustrate the performance of the proposed WPT model. The simulation results show the stable operation of the proposed system under the designed system parameters.

show abstract

“…The single-phase H-bridge inverter circuit includes four switching components, such as MOSFETs, IGBTs, etc. [18].…”

Section: Electronic Circuit and Controllermentioning

confidence: 99%

Design and Performance Investigation of a Series Compensated Inductive Wireless Power Transfer System for Supplying a Low Power DC Load

Buyuk

2024

Bitlis Eren Üniversitesi Fen Bilimleri Dergisi

View full text Add to dashboard Cite

show abstract

“…In this case, the machine's stator flux and electromagnetic torque are controlled without any modulation block. Then, a similar technique, but applied to the power, called Direct Power Control (DPC) was proposed by H. Nian in [4] and developed later by M. Malinowski in [5] for a control application of the rectifiers in replacement of the traditional command based on the regulation of current loops. In this new control technique, the controlled variables are the instant active and reactive powers.…”

Section: Introductionmentioning

confidence: 99%

Control of Doubly Fed Induction Generator Using Artificial Neural Network Controller

YAICHI,

SEMMAH,

WIRA

2023

RRST-EE

View full text Add to dashboard Cite

In this paper, we propose a direct power control (DPC) based on an artificial neural network (ANN-DPC) for the doubly-fed induction generator (DFIG), which is applied to the wind turbine system. The main objective of this intelligent technique is to replace the switching table and the hysteresis comparators with a neural control to reduce the ripple to the level of current and power. Field-oriented control (FOC) is traditionally achieved using a conventional proportional-integral controller (PI). The power ripples are reduced, and a reasonable total harmonic distortion rate is ensured by using an ANN-DPC.

show abstract

“…The neutral point voltage that corresponds to one half of the DC link voltage is available at the output of the phases when appropriate diodes are clamped. Moreover, five-level NPC is used to connect DG to the AC grid [166].…”

Section: Diode-clamped Mfi (Mfi-dc)mentioning

confidence: 99%

Review of Multifunctional Inverter Topologies and Control Schemes Used in Distributed Generation Systems

Teke¹,

Latran²

2014

Journal of Power Electronics

View full text Add to dashboard Cite

Recent developments in power electronics technology have spurred interest in the use of renewable energy sources as distributed generation (DG) generators. The key component in DG generators is a grid-connected inverter that serves as an effective interface between the renewable energy source and the utility grid. The multifunctional inverter (MFI) is special type of grid-connected inverter that has elicited much attention in recent years. MFIs not only generate power for DGs but also provide increased functionality through improved power quality and voltage and reactive power support; thus, the capability of the auxiliary service for the utility grid is improved. This paper presents a comprehensive review of the various MFI system configurations for single-phase (two-wire) and three-phase (three-or four-wire) systems and control strategies for the compensation of different power quality problems. The advances in practical applications and recent research on MFIs are presented through a review of nearly 200 papers.

show abstract

Linear enslavement of dc bus voltage of hybrid system wind-photovoltaic

Cited by 3 publications

References 2 publications

Design and Performance Investigation of a Series Compensated Inductive Wireless Power Transfer System for Supplying a Low Power DC Load

Design and Performance Investigation of a Series Compensated Inductive Wireless Power Transfer System for Supplying a Low Power DC Load

Control of Doubly Fed Induction Generator Using Artificial Neural Network Controller

Review of Multifunctional Inverter Topologies and Control Schemes Used in Distributed Generation Systems

Contact Info

Product

Resources

About