Low firing temperature ceramic for microcircuit substrates

Vartanyan, G. A.; Лукин, Е. С.; Попова, Н. А.

doi:10.1007/s10717-008-9008-3

Cited by 7 publications

(7 citation statements)

References 1 publication

Supporting

Mentioning

Contrasting

Order By: Relevance

“…3a ). The ultimate strength in bending of this material is 100 -120 MPa, the dielectric constant in the frequency range up to 10 6 Hz is 8.2, the tangent of the dielectric loss angle is 1´10 -3 -2´10 -3 [9]. With this in mind, a composition was studied in the CaO-B 2 O 3 -SiO 2 system relating to the eutectic point of 977°C.…”

Section: Group II New Dense Ceramic Materials Of Aluminum Oxidementioning

confidence: 99%

Nanopowders for preparing a new generation of oxide ceramics

et al. 2009

Self Cite

View full text Add to dashboard Cite

Future application is presented for ultra-and nanodispersed powders in the technology of simple and complex oxide ceramics. Ceramic materials based on these powders are considered relating to different functional classes, their properties, features of their preparation and fields of application are described in detail. The development of ceramic materials with high operating properties will make it possible to resolve important scientific and technical problems connected with developing new technology.

show abstract

Section: Group II New Dense Ceramic Materials Of Aluminum Oxidementioning

confidence: 99%

Nanopowders for preparing a new generation of oxide ceramics

et al. 2009

Self Cite

View full text Add to dashboard Cite

show abstract

“…Nevertheless, the manufacture of most of the glass materials is usually a complex process including high-temperature melting and cooling. At present, the multi-oxide systems, such as the eutectic systems CaO-B 2 O 3 -SiO 2 , CaO-B 2 O 3 -Al 2 O 3 , ZnO-SrO-B 2 O 3 and BaO-ZnO-SiO 2 -B 2 O 3 [4,5], can be developed to fabricate the ceramics with low sintering temperature. The eutectic compositions with melting temperature below 1000 o C can supply sufficient amounts of liquid phase to achieve the densification sintering of the low-temperature sintering ceramics.…”

Section: Introductionmentioning

confidence: 99%

Phase formation and properties of the BaO–B2O3–SiO2 and –Al2O3 ceramics prepared via an aqueous suspension route

Chen

Zhu

2012

Journal of Alloys and Compounds

View full text Add to dashboard Cite

“…Accordingly, barium borate can also be used to fabricate LTCC composite ceramics as a LTCC matrix [6,7], since the appropriate BaO-B 2 O 3 compositions have the potential to transform into a glassy form at a relative low sintering temperature (800-900 • C) [8,9]. Especially in order to achieve a densification sintering, the introduction of the ␣-alumina ceramic particles to the barium borate glassy matrix can offer more possibilities to set a proper sintering behavior and maximize mechanical strength [10][11][12][13][14]. With this understanding, the composite matrix (BBA) of the barium borate glassy matrix and the ␣-alumina ceramic particles can be well combined with other functional ceramic particles and consequently achieve tailored physical properties and dense microstructure.…”

Section: Introductionmentioning

confidence: 99%