“…The above correlation was found to be independent of the fluidization velocity or regime change from bubbling to slugging. Accordingly, Scala (2007) concluded that in a dense bubbling bed the active particle only reside in the dense phase and never enters the bubble phase, hence it has no direct contribution to the bubble-dense phase interchanges. This contradicts the observation noted by Kunii and Levenspiel (1991) and others (e.g.…”
Section: Mass Transfer Coefficient From Literaturementioning
confidence: 99%
“…Recently, Scala (2007) experimentally studied the mass transfer around a freely active particle in a dense fluidized bed of inert particles. The results suggested that the mass transfer coefficient for a single particle is best correlated by a modified Foressling ( .…”
Section: Mass Transfer Coefficient From Literaturementioning
“…The above correlation was found to be independent of the fluidization velocity or regime change from bubbling to slugging. Accordingly, Scala (2007) concluded that in a dense bubbling bed the active particle only reside in the dense phase and never enters the bubble phase, hence it has no direct contribution to the bubble-dense phase interchanges. This contradicts the observation noted by Kunii and Levenspiel (1991) and others (e.g.…”
Section: Mass Transfer Coefficient From Literaturementioning
confidence: 99%
“…Recently, Scala (2007) experimentally studied the mass transfer around a freely active particle in a dense fluidized bed of inert particles. The results suggested that the mass transfer coefficient for a single particle is best correlated by a modified Foressling ( .…”
Section: Mass Transfer Coefficient From Literaturementioning
“…4) the active particle density is explicitly present. In the experiments performed by Scala (2007) this variable was varied in a relatively limited range (1050 < ρ a < 1950 kg/m 3 ), and within this range it appeared not to influence significantly Sh. It is our opinion that if particle segregation is avoided, the active particle density has no importance on mass transfer, but this speculation needs further experimental confirmation.…”
Section: Comparison Of Available Correlations With Experimental Datamentioning
confidence: 99%
“…In addition, if high CO concentrations are used the heat balance must be solved together with the mass balance (or the particle temperature must be measured during the experiments) as a consequence of the appreciable heat effects of combustion. Scala (2007) applied this technique to measure the mass transfer coefficient around freely moving active particles under bubbling/slugging fluidized bed conditions in a lab-scale reactor. In this work the mass transfer coefficient around one or few attrition-resistant Pt catalyst spheres immersed in an inert bed of sand was measured by following the CO oxidation reaction at 450°C at different fluidization velocities, catalyst sphere sizes and inert bed particle sizes.…”
Section: Chemical Reaction On the Surface Of Catalyst Particlesmentioning
confidence: 99%
“…The available empirical/theoretical correlations reported in the previous sections were checked for their accuracy in predicting the experimental mass transfer data of Scala (2007), which we consider to be the most complete and accurate reported in the literature to date. As a preliminary screening, all the correlations which predict a (direct or indirect) influence of the total fluidization velocity on Sh were discarded (Eqs 8-13, 17-19), as they are incompatible with the experimental data.…”
Section: Comparison Of Available Correlations With Experimental Datamentioning
Experiments on drying of moist particles by ambient air were carried out to measure the mass transfer coefficient in a bubbling fluidized bed. Fine glass beads of mean diameter 125 m were used as the bed material. Throughout the drying process, the dynamic material distribution was recorded by Electrical Capacitance Tomography (ECT) and the exit air condition was recorded by a temp/humidity probe. The ECT data were used to obtain qualitative and quantitative information on the bubble characteristics. The exit air moisture content was used to determine the water content in the bed. The measured overall mass transfer coefficient was in the range of 0.0145-0.021 m/s. A simple model based on the available correlations for bubble-cloud and cloud-dense interchange (two-region model) was used to predict the overall mass transfer coefficient. Comparison between the measured and predicted mass transfer coefficient have shown reasonable agreement with the measurements. The results were also used to determine the relative importance of the two transfer regions.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.