Materials characterisation part II: tip geometry of the Vickers indenter for microindentation tests

Jamal, Mikdam; Morgan, Michael N.

doi:10.1007/s00170-017-0176-6

Cited by 2 publications

(1 citation statement)

References 23 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The research in this study was focused on alternative approaches that use inverse FEM accompanied by an optimization algorithm to obtain and optimize the elastic plastic and Drucker-Prager material properties. It builds on the prior research of the authors reported in [12,13]. The proposed framework will enable the characterisation of complex material systems.…”

Section: Introductionmentioning

confidence: 99%

Characterization of Material Properties Based on Inverse Finite Element Modelling

Jamal

Morgan

2019

Inventions

View full text Add to dashboard Cite

This paper describes a new approach that can be used to determine the mechanical properties of unknown materials and complex material systems. The approach uses inverse finite element modelling (FEM) accompanied with a designed algorithm to obtain the modulus of elasticity, yield stress and strain hardening material constants of an isotropic hardening material model, as well as the material constants of the Drucker–Prager material model (modulus of elasticity, cap yield stress and angle of friction). The algorithm automatically feeds the input material properties data to finite element software and automatically runs simulations to establish a convergence between the numerical loading–unloading curve and the target data obtained from continuous indentation tests using common indenter geometries. A further module was developed to optimise convergence using an inverse FEM analysis interfaced with a non-linear MATLAB algorithm. A sensitivity analysis determined that the dual spherical and Berkovich (S&B) approach delivered better results than other dual indentation methods such as Berkovich and Vickers (B&V) and Vickers and spherical (V&S). It was found that better convergence values can be achieved despite a large variation in the starting parameter values and/or material constitutive model and such behaviour reflects the uniqueness of the dual S&B indentation in predicting complex material systems. The study has shown that a robust optimization method based on a non-linear least-squares curve fitting function (LSQNONLIN) within MATLAB and ABAQUS can be used to accurately predict a unique set of elastic plastic material properties and Drucker–Prager material properties. This is of benefit to the scientific investigation of properties of new materials or obtaining the material properties at different locations of a part which may be not be similar because of manufacturing processes (e.g., different heating and cooling rates at different locations).

show abstract

Section: Introductionmentioning

confidence: 99%