Measurement of the phase-transfer function of the software phase-locked loop

Bondariev, Andriy; Altunin, Serhiy

doi:10.1109/ukrmico.2017.8095379

Cited by 5 publications

(8 citation statements)

References 2 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In the paper [19], the frequency response characteristics of the DDS-based PLL are analyzed, but it also does not consider the noise properties.…”

Section: Literature Review and Problem Statementmentioning

confidence: 99%

“…Thus, the above-mentioned works lack one of two aspects: -methods of noise immunity improvement with simultaneous preservation of their dynamic properties have not been investigated [3,4,8,10,11,[16][17][18][19];…”

Section: Literature Review and Problem Statementmentioning

confidence: 99%

“…where m is the proportionality coefficient, T f c = 1 2π is the time constant, f c is the cutoff frequency of the filter. The mechanism of calculation of DF coefficients is given in [19].…”

Section: Classical Pllmentioning

confidence: 99%

“…This pair of parameters gives a possibility to evaluate the shape of the PLL frequency response with high accuracy and estimate values in its key points [20]. The connection between the normalized parameters {ω n , ζ} and LPF parameters of the device is given in [19].…”

Section: Classical Pllmentioning

confidence: 99%

“…1. Block diagram of the classical PLL [19] In order to restore the information signal spectrum correctly without distortions, it is necessary to select the right parameters of the HPF located after the detector. Its frequency response must be inverse to the NBF frequency response, i. e. K NBF (s)K HPF (s) = const.…”

Section: Block Diagram Of the Pll With The Modified Phase Detectormentioning

confidence: 99%

See 4 more Smart Citations