Measuring Bus Stop Dwell Time and Time Lost Serving Stop with London iBus Automatic Vehicle Location Data

Abstract

There is considerable research in the literature on the dwell time of buses at bus stops. However, common measures of dwell time do not consider the time lost by the bus decelerating and accelerating from a stationary speed to serve the stop. This paper identifies eight features that are observed when a bus serves a bus stop. These features were used to propose a definition of dwell time that can be measured with bus automatic vehicle location systems. A proposed metric gives the time that would have been saved had the bus stop not been present in the road network. Metrics were calculated for all bus stops on Route 45 in London; more than 50,000 stop visit events were used for the calculation. The time lost arriving at (i.e., decelerating) and departing from (i.e., accelerating) the bus stop was typically 11.6 s. This interval was often much longer than the time lost when the doors were open at the bus stop. Buses were shown to lose significant time serving a bus stop even if the bus never came to a halt at the stop. The method proposed in this paper can be used by transit agencies to measure the actual drive time of buses, removing the component of time lost serving the bus stop. The method can be used to identify bus stops that may need redesign to reduce the time lost in arriving and departing. A novel contribution of this research is that all proposed metrics can be automatically measured with modern automatic vehicle location systems, allowing easy collection of information.

Real-time Bus Route State Forecasting Using Particle Filter: An Empirical Data Application

“…Finally, on a link, a bus accelerates to reach its free-flow speed and decelerates to stop at the next stop. In practice, a bus does not stop if no passenger wants to board or alight the bus (Robinson, 2013). In such a case, the bus does not lose any time in acceleration and deceleration.…”

Optimal Limited-stop Bus Routes Selection Using a Genetic Algorithm and Smart Card Data

“…[Robinson 2013]) OnOffTime n = boarding and alighting time at n th stop (2.3 sec/passenger for boarding and 2.0 sec/passenger for alighting (from smart card data), applying larger value between total boarding time and total alighting time)…”

Modeling Bus Dwell Time and Time Lost Serving Stop in China

“…In light of this, bus dwell time and time lost serving stop is introduced to describe the bus service procedure in this study, which is defined as the time required for serving passengers, acceleration time, and deceleration time, with the addition of dead time. According to relevant references (Robinson 2013;Cundill and Watts 1973), dead time is the time the bus is stationary at a stop but no passengers are boarding and alighting. The contributing factors for dead time are categorized as major factors (including the average delay for re-entering the car stream (Yang et al 2009), and other additional delay (Tirachini 2013) such as boarding lost time, bus stop failure time, and traffic signal delay, and adjustment factors (including traffic volume/capacity).…”