Mechanical and tribological behavior of friction stir welded joint on AA 8011 at diverse strengthening condition through post processing

Soundararajan, R.; Aravinth, Vishaal; Vallarasu, M.; Ranjith, S.

doi:10.1016/j.matpr.2020.03.035

Cited by 3 publications

(1 citation statement)

References 19 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…al. analysed the welding variables that affect the hardness and tensile values of welded joints of dissimilar aluminium 7075 and aluminium 8011 Analysis has been done on the effects of the weld speed and rotation rate on the microstructure and mechanical characteristics [4]. R.K.Mishra focused the consequences of uncorroded and corroded aluminium 8011 alloys to study the surface degradation of the alloys for different environmental conditions,8011 alloy exposes the some pits in the surface it will leads to the crack failure, The intergranular corrosion of the alloy was evident from the muddy look of the SEM results that show fracture initiation from corrosion pits.Al alloy 8011, one of many aluminum alloys, has a good balance of flexibility and strength.…”

Section: Introductionmentioning

confidence: 99%

Study of mechanical behaviour & microstructural properties on friction stir welded aluminium alloys 6082 - t6&8011

Sivabalan,

Sridhar,

Ajith Arul Daniel

et al. 2024

E3S Web Conf.

View full text Add to dashboard Cite

In this study 6082 T6 aluminium alloys and 8011 aluminium alloys of 5mm Thickness by using a friction stir welding procedure, plates were connected. weldments are carried out by varying various parameters such as Tool rotational rates are varies from(600 rpm,800 rpm,1000 rpm),Traverse speed are varies from(10 mm/min,20 mm/min,30mm/ min) Axial Forces are varies from (4 kn,6 kn,8 kn) and Tilt angle maintains 10.This process performed by nonconsumable tool as Hexagonal,cylindrical and square pin profiles to generate a heat energy and plastic atomic diffusion's are made in the weldments. The fractography microstructure of tensile specimen shows minimum failure when the tool rotational speed is 800rpm, traverse speed at 20 mm/min and axial force 8KN.

show abstract

Section: Introductionmentioning

confidence: 99%