Mechanical Performance of Unstitched and Silk Fiber-Stitched Woven Kenaf Fiber-Reinforced Epoxy Composites

Abstract

Fiber composites are known to have poor through-thickness mechanical properties due to the absence of a Z-direction binder. This issue is more critical with the use of natural fibers due to their low strength compared to synthetic fibers. Stitching is a through-thickness toughening method that is used to introduce fibers in the Z-direction, which will result in better through-thickness mechanical properties. This research was carried out to determine the mechanical properties of unstitched and silk fiber-stitched woven kenaf-reinforced epoxy composites. The woven kenaf mat was stitched with silk fiber using a commercial sewing machine. The specimens were fabricated using a hand lay-up method. Three specimens were fabricated, one unstitched and two silk-stitched with deferent stitching orientations. The results show that the stitched specimens have comparable in-plane mechanical properties to the unstitched specimens. For the tensile mechanical test, stitched specimens show similar and 17.1% higher tensile strength compared to the unstitched specimens. The flexural mechanical test results show around a 9% decrease in the flexural strength for the stitched specimens. On the other hand, the Izod impact mechanical test results show a significant improvement of 33% for the stitched specimens, which means that stitching has successfully improved the out-of-plane mechanical properties. The outcome of this research indicates that the stitched specimens have better mechanical performance compared to the unstitched specimens and that the decrease in the flexural strength is insignificant in contrast with the remarkable enhancement in the impact strength.

A Review on Synthetic Fibers for Polymer Matrix Composites: Performance, Failure Modes and Applications

“…However, over the past 20 years, SFs such as ceramic fabrics, carbon fibers, glass fibers, basalt fibers, and polymeric fibers have received special attention [ 5 , 6 ]. Because SFs provide high strength and inertia, they are widely used in the production of advanced composite materials in aerospace and automotive environments [ 7 ].…”

Weld Strength of Friction Welding of Dissimilar Polymer Rods Fabricated by Fused Deposition Modeling

“…An infrared thermal imager is used to monitor the peak temperature of weld joint during FRW. Three-point bending tests [31][32][33] and impact tests [34,35] are applied to evaluate the mechanical properties of the specimens after FRW. Optical microscopy, energy dispersive spectroscopy, and field-emission scanning electron microscopy were used to investigate the microstructure of welding zone.…”

Removal of heavy metals from aqueous solutions by modified waste silk

“…They are have limited applications in other fields, such as civil engineering, packaging, agriculture, medical aircraft, aircraft, electronics, etc. 15,16 As the world's largest textile exporter and producer, China plays an important role in the global textile supply chain. 17 Approximately 45% of textiles produced in China are wasted, ranging from pre-consumer waste composed of fabrics, materials, and clothing processing, to post-consumer waste when discarding used clothing.…”