Mechanical Properties of the Mg-Gd-Y-Zn-Zr Alloys with Different Morphologies of Long-Period Stacking Ordered Phases

Zhou, Xiaojie; Liu, Chuming; Gao, Yonghao; Jiang, Shunong; Chen, Zhiyong

doi:10.1007/s11665-018-3713-z

Cited by 33 publications

(2 citation statements)

References 37 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Magnesium alloys have the significant effect of reducing weight in the automotive and aerospace industries due to their low density and high specific strength [ 6 , 7 , 8 , 9 , 10 , 11 , 12 , 13 ]. In recent years, rare earth magnesium alloys have received increasing attention due to their high performance at both room and high temperatures [ 14 , 15 , 16 , 17 ]. Li et al [ 18 ] used computer-aided cooling curve analysis technology to study the solidification pathways and structures of Mg-Gd-Y-Zr alloys with different Gd and Y concentrations.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Simulation Study on Temperature and Stress Fields in Mg-Gd-Y-Zn-Zr Alloy during CMT Additive Manufacturing Process

Zhao,

et al. 2024

Materials

View full text Add to dashboard Cite

A new heat source combination, consisting of a uniform body heat source and a tilted double ellipsoidal heat source, has been developed for cold metal transfer (CMT) wire-arc additive manufacturing of Mg-Gd-Y-Zn-Zr alloy. Simulations were conducted to analyze the temperature field and stress distribution during the process. The optimal combination of feeding speed and welding speed was found to be 8 m/min and 8 mm/s, respectively, resulting in the lowest thermal accumulation and residual stress. Z-axis residual stress was identified as the main component of residual stress. Electron Backscatter Diffraction (EBSD) testing showed weak texture strength, and Kernel Average Misorientation (KAM) analysis revealed that the 1st layer had the highest residual stress, while the 11th layer had higher residual stress than the 6th layer. Microhardness in the 1st, 11th, and 6th layers varies due to residual stress impacts on dislocation density. Higher residual stress increases dislocation density, raising microhardness in components. The experimental results were highly consistent with the simulated results.

show abstract

Section: Introductionmentioning

confidence: 99%

“…Figure13shows the pole figures and IPF figures of the (0001) plane, (10-10) plane, and(11)(12)(13)(14)(15)(16)(17)(18)(19)(20) plane in the 1st layer, the 6th layer, and the 11th layer. The additive region of the alloy is composed of equiaxed crystals, and the crystals have no obvious orientation.…”

mentioning

confidence: 99%