Microstructure-mechanical properties relationships in vibration welded glass-fiber-reinforced polyamide 66: A high-resolution X-ray microtomography study

Abstract

The effect of initial fiber orientation and welding conditions on the mechanical properties and microstructure of 30 wt% glass-fiber-reinforced polyamide 66 was systematically evaluated. For all conditions studied no significant change in the polymer matrix was evidenced. However, fibers in the welded zone were reoriented toward the squeeze and vibration flows and this reorientation is related to the appearance of cavities, as evidenced by high-resolution synchrotron-based X-ray microtomography. It is shown that stress at break values of the welded samples increase with the thickness of the weld zone together with the minimum value of the fiber orientation tensor component in the tensile direction. A drop of strain at break is also related to an increase in the fibers' concentration in the weld. The maximum void volume fraction being measured on samples which have the thickest welded zones, counterintuitively it does not induce lower stress at break.

Origin of embrittlement in Polyamide 6 induced by chemical degradations: mechanisms and governing factors

“…Polyamide materials are widely used by the automotive industry [4][5][6], in oil and gas application, and also for wind turbine moorings [7]. Polyamide production has increased in the last 20 years to reach 5.5 million tonnes in 2015 [8] so the long-term behaviour of these polymers will become important in the future.…”

Time and Spatially Resolved Operando Small-Angle X-ray Scattering Measurements during Injection Moulding of Plastics

“…Filled polymers are a common class of industrial materials used in injection moulding. Again, the level of X-ray absorption may be a problem, but we have previously successfully performed SAXS/WAXS experiments on polyamide/glass fibre materials with up to 40% glass fibres [37]. Polyolefins with carbon black, graphene, or carbon nanotubes will present no problems, as the absorption of the filler is similar to the polymer.…”

Influence of Thermal Shocks on Residual Static Strength, Impact Strength and Elasticity of Polymer-Composite Materials Used in Firefighting Helmets

“…The thickness of the heat-affected zone is obviously varied in the selected test conditions of thermal shocks ( Table 2 ). The work [ 22 ] states that the heat-affected zone can consist of recrystallized or deformed spherulites and has a structure of layers with a thickness of up to approximately 100 μm. The size and distribution of these layers within the heat-affected zone may vary depending on a material type and processing conditions [ 20 ], mainly heat treatment.…”