Modeling and Fault Simulation of a New Double-Redundancy Electro-Hydraulic Servo Valve Based on AMESim

Abstract

The feedback spring rod of the armature assembly was eliminated in the double-redundancy electro-hydraulic servo valve (DREHSV), which employed a redundant design in contrast to the typical double-nozzle flapper electro-hydraulic servo valve (DNFEHSV). The pilot stage was mainly composed of four torque motors, and the double-system spool was adopted in the power stage. Consequently, the difficulty of spool displacement control was increased. By artificially changing the structural parameters of the simulation model in accordance with the theoretical analysis through AMESim, this paper aimed to study the dynamics and static characteristics of the DREHSV. The advantage of redundant design was further demonstrated by disconnecting working coils and setting the different worn parts of the spool. On the test bench, the necessary experiments were performed. Through simulation, it was discovered that when the clogged degree of the nozzle is increased, the zero bias value increases, the pressure and flow gain remain unchanged, and the internal leakage decreases. The pressure gain changes very little, the flow gain close to the zero position grows, the zero leakage increases significantly, and the pilot stage leakage changes very little as a result of the wear of the spool throttling edge. The basic consistency between the simulation curves and the experimental findings serve to validate the accuracy of the AMESim model. The findings can serve as a theoretical guide for the design, debugging, and maintenance of the DREHSV. The simulation model is also capable of producing a large amount of sample data for DREHSV fault diagnosis using a neural network.

Design Method of the Stroke Ring Based on Deformation Pre-Compensation

“…Through the motor structure parameters, a single-piston hydraulic model was established in AMESim [26], as shown in Figure 6. The model consists of a distribution module, a piston module, a stroke ring module, and a control module.…”