“…A similar situation is valid also for the o -Ps dispersion. In addition, some further features consisting of the presence of basically four regions A–D with distinct thermal behavior of o -Ps annihilation parameters can be distinguished as usually found for many amorphous organics. ,,− They can be described by the following three characteristic PALS temperatures, depicted as T g PALS ( c ) ≅ 180 K, T b1 L ( c ) ≅ 230 K, and finally T b2 L ( c ) ≅ 265 K. The ascription of the first value to the glass-to-liquid transition is strongly supported by the fact that the relative characteristic PALS temperatures T b1 L ( c )/ T g PALS ( c ) = 1.28 and T b2 L ( c )/ T g PALS ( c ) = 1.47reach the typical values observed for amorphous substances. ,,− It is useful to recall that the T b1 L effect in amorphous organics is related to a crossover of the amorphous phase between its strongly and weakly supercooled liquid states, ,,, while the plateau phenomenon is the specific effect of the PALS technique, which can be connected with the formation of the bubblelike character of the free volume at relatively higher- T values with the corresponding T g values. , On the other hand, the atypically high ratios for n -BuOH, i.e., T b1 L ( c )/ T g PALS ( c ) = 1.87 and T b2 L ( c )/ T g PALS ( c ) = 2.1, are associated with a rather distinct origin of the changes connected with the phase transformations, as supported by the DSC data. Finally, it is of interest to mention that the so-ascribed T g PALS ( c ) ∼ 180 K is in good agreement with the aforementioned two estimations of the glass-to-liquid transition temperatures T g DMS ( b ) = 173 and 180 K for amorphous t -BuOH from special DMS experiments. , On the other hand, the apparent absence of the typical stepwise effect in our DSC response for the confined t -BuOH/MCM-41-SIL system might be related to both the large mean free volume hole sizes and the relative very flat bend effect in the τ 3 vs T dependence together with the very pronounced free volume distribution.…”