Monito-Ring: An original fiber optic system for morphing application

Abstract

An original Monito-Ring system based on chirped fiber optic and draw tower grating array is presented. The target of this research activity is the realization of a device able to measure deformations of morphing structures which may show large, global displacements due to nonstandard architectures and materials adopted. The occurring strain field results, in turns, much more than the standard sensors can handle. Modulations are then necessary to keep the measured strain low. The proposed solution was conceived to overcome this limitation assuring a suitable reduction of the revealed strain. The concept is made of a flexible ring pinned on a certain number of points to the structural component of interest. The fiber optic is integrated within the ring, and depending on the angular position of the sensor, the ratio between the diameter elongation (i.e. structural strain) and the measured deformation (strain) can be almost arbitrarily set in a large range of values. From each spectrum provided by draw tower grating array, the corresponding unknown strain field is retrieved by applying an inverse technique obtaining an accurate continuous strain map. This article deals with a proof of concept analytical study first and then numerical and experimental validation.

Shape Memory Polymer Composite Actuator: Modeling Approach for Preliminary Design and Validation

“…In the last two decades, the use of optical fibres and related optical components has dramatically increased with the development of a large variety of fibre optic sensors with the possibility of realizing sensing technologies, which are highly competitive with respect to traditional, less expensive, electrical sensors [11,20,32]. High strain, high temperature, and continuous monitoring can be highlighted [33].…”

Interfacial adhesion between embedded fibre optic sensors and epoxy matrix in composites

“…Monitoring systems with fibre optic sensors are used for both damage detection and usage monitoring in a wide range of applications, such as: the study and prediction of crack propagation in adhesive joints [4,5,6,7], strain and displacement monitoring of aeronautical structures [8,9,10,11,12] and civil infrastructures [13,14,15].…”

Circular Patch Sensor Based on Distributed Fiber Optic Technology for Tensile and Bending Loads Identification

“…The MonitoRing [5,6], the authors previously developed for high displacements measurements within morphing applications scenario, is proposed in this paper with an innovative layout, for the preliminary identification of simple loading conditions. In this paper, the attention is devoted to the implemented methodology.…”