MPI with a mechanically rotated FFL

Weber, Matthias; Bente, Klaas; Gladis, Anselm von; Buzug, Thorsten M.

doi:10.1109/iwmpi.2015.7107026

Cited by 3 publications

(1 citation statement)

References 4 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…For three‐dimensional imaging, the FFL should also be rotated. The rotation of the FFL with respect to the object can be done both mechanically and electronically . Electronic scanning has the advantages of reduced scan time, and flexibility for different scanning sequences.…”

Section: Introductionmentioning

confidence: 99%

Trajectory analysis for field free line magnetic particle imaging

et al. 2019

View full text Add to dashboard Cite

Purpose Magnetic particle imaging (MPI) is a relatively new method to image the spatial distribution of magnetic nanoparticle (MNP) tracers administered to the body with high spatial and temporal resolution using an inhomogeneous magnetic field. The spatial information of the MNP's is encoded using a field free point (FFP), or a field free line (FFL), in which the magnetic field vanishes at a point, or on a line, respectively. FFL scanning has the advantage of improved sensitivity compared to FFP scanning as a result of higher signal‐to‐noise ratio. The trajectory traversed by the FFL or FFP is an important parameter of the MPI system and should be selected to achieve the best imaging quality in minimum scan time, while considering hardware constraints and patient safety. In this study, we analyzed the image quality of different FFL trajectories for a large field of view (FOV) using simulations, to provide a baseline information for FFL scanning MPI system design. Methods We simulated a human‐sized FFL scanning MPI configuration to image a circular FOV with 160 mm diameter, and compared Radial, Spiral, Uniform Spiral, Flower, and Lissajous trajectories with different trajectory densities scanned by the FFL for constant scan time. We analyzed the system matrices of the trajectories in terms of mutual coherence and homogeneity of the spatial sensitivity. We calculated the maximum electric fields induced on a homogeneous conductive body by the selection field (SF) and the focus field (FF) to compare the trajectories based on the nerve stimulation threshold. The images were obtained using the system matrix reconstruction approach with two different image reconstruction methods. In the first one, we used the conventional image reconstruction method, algebraic reconstruction technique (ART), which gives a regularized least‐squares solution. In the second one, we used the state‐of‐the‐art alternating direction method of multipliers (ADMM), which minimizes a weighted sum of the l1‐norm and the total variation (TV) of the images. Results The Radial and Spiral trajectories resulted in a poor imaging performance at low trajectory densities due to relatively high coherency and poor sensitivity of the measurements, respectively. For ART reconstruction, the highest image quality with the lowest trajectory density was achieved with the Uniform Spiral trajectory. Uniform Spiral, Flower, and Lissajous trajectories yielded comparable performance with ADMM reconstruction. The rotating SF induced higher electric field amplitude compared to the FF. Consequently, maximum allowable gradient at the same trajectory density was greater for the Radial trajectory compared to the other trajectories. Conclusions For a large FOV coverage, the Uniform Spiral trajectory offers a good compromise between image quality and imaging time, taking safety and hardware limitations into account. The Radial trajectory, especially using l1‐norm and TV priors in the reconstruction, may be favorable in case the SF induced electric field is higher than that of...

show abstract

Section: Introductionmentioning

confidence: 99%