Multi-loop control strategies of three-phase two-level current source inverter for grid interfacing photovoltaic system

Azmi, Syahrul Ashikin; Tajuddin, Mohammad Faridun Naim; Machmoum, Mohamed; Hwai, Leong Jenn

doi:10.1109/cencon.2017.8262498

Cited by 8 publications

(10 citation statements)

References 16 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In (Yao et al, 2015), an improved control strategy is proposed for the threephase grid-connected inverter with space vector pulsewidth modulation (SVPWM). In (Azmi et al, 2017), it presents a control strategy that uses the number of feedback loops to allow fast and accurate tracking of the desired set points with the small of overshoot.…”

Section: Introductionmentioning

confidence: 99%

“…Where the voltage variation is considered according to the temperature and irradiance levels of the solar panel. PLL controller was implemented as in (Yao et al, 2015) (Azmi et al, 2017) to perform the synchronism of the signal generated by the converter and the electric network. And also control in the current mode as in (Yao et al, 2015) to perform control of the power flow transferred to the output.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

PLL and Current Mode Control Design Methodologies Applied to Improve the Performance of a Grid-Tie Photovoltaic System

Carvalho

Medeiros

Bessa

et al. 2019

Anais Do 14º Simpósio Brasileiro De Automação Inteligente

View full text Add to dashboard Cite

Currently, several forms of electric generation have been investigated, one of the most promising being the photovoltaic system. These systems produce electricity in DC format and the electrical networks in AC format, being necessary to use DC-AC converters to make the connection between the photovoltaic source and the conventional grid. For this work, it is proposed to use the current mode control and the Phase-Lock-Loop (PLL) to ensure the synchronization of the connection of the photovoltaic panels in the network. In both controllers, PI control structures are used. In the PLL the gains are obtained by the Roots Locus method and CHR method and the Current Mode Control the gains were obtained by the poles and zeros cancellation method. Finally, simulations were performed for panel irradiance variation, and also for temperature variation. For voltage sag in the PLL controller and reference change for the operation of the Current Mode control.

show abstract

Section: Introductionmentioning

confidence: 99%

Section: Introductionmentioning

confidence: 99%

PLL and Current Mode Control Design Methodologies Applied to Improve the Performance of a Grid-Tie Photovoltaic System

Carvalho

Medeiros

Bessa

et al. 2019

Anais Do 14º Simpósio Brasileiro De Automação Inteligente

View full text Add to dashboard Cite

show abstract

“…Since this system is the source of power, it must be able to specify and control the voltage and frequency of its output. The dedicated control system in this mode must provide sufficient active and reactive power to match the connected loads whilst delivering output voltage with high power quality [19][20][21][22]. The grid is an integrated network of generation, high-voltage transmission, substations and local distribution.…”

Section: Introductionmentioning

confidence: 99%

“…Among two basic inverter technologies available, the current source inverter (CSI) is perceived to be suitable for grid integration of multi-megawatt wind turbines and photovoltaic systems as compared to voltage source inverter [1,[3][4][5][6][7][8][9]. For example, the CSI provides a simple topological solution and satisfactory performance in grid mode, giving sinusoidal current, fully controlled power factor, and natural protection against dc side short-circuit faults [15][16][17][18][19][20]. Current source inverter is proven to be the key player in high power, medium voltage ac drives systems with ac voltages of 2.3kV to 13.8kV [2,3,14].…”

mentioning

confidence: 99%

Voltage-controlled of a three-phase current source inverter in islanded operation

Azmi

Adam

Rahim

2019

IJEECS

View full text Add to dashboard Cite

This paper presents the performance of a three-phase current source inverter (CSI) in island mode voltage-controlled operation. Simple converter structure, low switching count and inherent boosting capability among the features offered by CSI. However, less investigation has been done with regards to the performance of CSI especially on its control system for island and grid-connected photovoltaic system. Thus, this study aims to investigate the suitability of proportional-integral (PI) and proportional-resonant (PR) control including their dynamic equations and state-space modeling. The results show that both controllers able to perform satisfactory in achieving zero steady-state error and balanced sinusoidal output voltage and current. PI control is superior in fast response time and excellent harmonic rejection than inverter using PR control PR control on the other hand, able to give more robust performance during imbalance occur than PI control due to individual control of the phases. This study may becomes one of the references with regard to current source inverter for early career researchers. as All results presented in this paper are verified with varying operational parameters in MATLAB/ SIMULINK platform.

show abstract

“…Various techniques to eliminate the harmonics are proposed in literature [13][14]. Comparative study of %THD of different output voltage levels of multi-level inverters are discussed in [15]. A three phase grid connected current source inverter with multi loop feedback control strategies are discussed [16].…”

Section: Introductionmentioning

confidence: 99%

Analysis of Multi Level Current SourceInverter for LowTorque Applications

Mahalakshmi

Deepa

Thampatty

2018

JGE

View full text Add to dashboard Cite

This paper proposes a control strategy for a multi-level Current Source Inverter (CSI) which acts as an interface between renewable energy sources such as wind, solar, fuel cell etc. and grid/loads to satisfy the power demand. The control strategy aims to reduce the number of switches and the number of input sources used in the CSI and obtain an output with least Total Harmonic Distortion (THD) and increased number of levels (13). The proposed system uses seven switches and three current sources to obtain a 13 level output. The new control strategy is tested in different operating conditions in a split phase single phase low torque induction motor. The Simulation model is developed in MATLAB/Simulink. THDs of 13 level outputs from current source inverter is analyzed and compared in detail. A comparative analysis of the proposed CSI with existing CSI topologies is made. It is observed that the proposed topology uses less number of switches and inductors to obtain different levels at the output. The proposed inverter provides better performance with satisfactory results.

show abstract

Multi-loop control strategies of three-phase two-level current source inverter for grid interfacing photovoltaic system

Cited by 8 publications

References 16 publications

PLL and Current Mode Control Design Methodologies Applied to Improve the Performance of a Grid-Tie Photovoltaic System

PLL and Current Mode Control Design Methodologies Applied to Improve the Performance of a Grid-Tie Photovoltaic System

Voltage-controlled of a three-phase current source inverter in islanded operation

Analysis of Multi Level Current SourceInverter for LowTorque Applications

Contact Info

Product

Resources

About