Needleless Electrospinning of PA6 Fibers: The Effect of Solution Concentration and Electrospinning Voltage on Fiber Diameter

Abstract

Needleless electrospinning is the process of forming thin material fibers from the open surface of its solution or melt in a strong electrostatic field. Electrospun non-woven materials are used in various applications that require specific fiber diameters and pore size distributions. Fiber diameter depends on the properties of the polymer solution and manufacturing conditions. A needleless electrospinning process using the Nanospider setup was investigated using the commonly used polyamide 6 (PA6) solution in a mixture of acetic and formic acids. Polymer solutions with different polymer concentrations were characterized by viscosity, surface tension and electrical conductivity. An increase in polymer content in the solution resulted in the exponential increase of the solution viscosity, polynomial increase of electrical conductivity and had almost no effect on surface tension. The effect of the polymer concentration in the solution, as well as electrospinning voltage on fiber diameter and diameter distribution, was investigated using scanning electron microscopy images. The average fiber diameter linearly increases with the increased polymer concentration and also demonstrates an increase with increased electrospinning voltage, although less pronounced. Therefore, a change in the PA6 solution concentration should be used for the robust adjustment of fiber diameter, while changes in electrospinning voltage are more appropriate for fine tuning the fiber diameter during the process of needleless electrospinning.

Rapid preparation of electrospun nanofibre sponges through supercritical CO2 drying

“…This agrees well with values reported by Mousavi et al (175 ± 49 nm) and Aulova et al (183 ± 47 nm). 35,36 Then, we suspended the NFMs in t -BuOH/H 2 O 20% w/w, cut, and homogenized them, to obtain a suspension of short nanofibres with a length of 60.1 ± 19.6 μm ( n = 117). The short nanofibres in the suspension were clearly separated as confirmed by SEM analysis from dried samples, Fig.…”

Preparation of Electrospun Styrofoam Membranes for Hydrogen Fuel Cells

“…As a practical example, the higher molecular weight, the higher fiber diameter. Changing the conductivity of solution will affect the viscosity as well as surface tension of solutions [17,18] It is important to mention that surface tension of solution is the reason of beads formation or in other words (beaded fibers) [19]. Styrofoam has special characteristics such as small weight, low density, dimensional stability, low thermal conductivity coefficient, versatility, and low cost [21].…”