Needs Assessment of Gossamer Structures in Communications Platform End-of-Life Disposal

Abstract

The use of a gossamer structure is considered in application to end-of-life disposal of communications platforms. A wide-ranging survey of end-of-life disposal techniques and strategies is presented for comparison against a gossamer structure prior to a down-selection of viable competing techniques; solar sailing, high and low-thrust propulsion, and electrodynamic tethers. A parametric comparison of the down-selection competing techniques is presented where it was found that exploiting solar radiation pressure on the gossamer structure was of limited value. In general terms, it was found that if a spacecraft propulsion system remains functioning at the end-of-life then this will likely provide the most efficient means of re-orbiting, especially when the propulsion system is only used to lower the orbit to a point where atmospheric drag will cause the orbit to decay within the required timeframe. Atmospheric drag augmentation was found to be of most benefit for end-of-life disposal when an entirely passive means is required, allowing the device to act as a 'fail-safe', which if the spacecraft suffers a catastrophic failure would activate. The use of an atmospheric drag augmentation system is applicable to only low and medium mass spacecraft, or spacecraft that are unlikely to survive atmospheric re-entry, hence minimizing risk to human life.

Towards a Satellite System for Archaeology? Simulation of an Optical Satellite Mission with Ideal Spatial and Temporal Resolution, Illustrated by a Case Study in Scotland

“…Assuming a power law fit to the 1976 standard atmosphere [36], the time for a spacecraft to naturally decay to a certain altitude, h 1 , as a function of time can be defined as [37]…”

Investigation of very low Earth orbits (VLEOs) for global spaceborne lidar

“…For the purposes of this study, the force from atmospheric drag ( F D ) experienced on a spacecraft can be be represented by where d is the atmospheric density, V is the orbital velocity, is the cross sectional area of the spacecraft in the velocity direction and C D is the drag coefficient. Orbital velocity can be calculated as and, ignoring regional, seasonal and solar-cycle induced variations in atmospheric conditions, atmospheric density (d, in kg/m 3 ) can be approximated using a power-law curve fit to the 1976 Standard Atmosphere model [21], such that where Λ = 10 7 , = 7.201 and h is the orbit altitude (in km). Note that this relationship is derived from a power-law curve fit to empirical data, such that the dimensions do not need to match.…”

Incorporating Solar Activity into General Perturbation Analysis of Atmospheric Friction

“…Traditionally, an exponential curve fit is used, however such curves are generally only applicable when considering altitudes up to 100km; when considering higher altitudes they become less accurate [5]. Macdonald et al proposed a power fit model however did not expand on how accurate it may be in comparison to the exponential fit [42].…”