“…Among them, a-Si TFTs have been widely used for flat-panel X-ray detectors; however, they suffer from low carrier mobility, thereby necessitating a large TFT with a large parasitic data line capacitance, which increases electronic noise and reduces the pixel fill factor. , The carrier mobility of the LTPS TFT is approximately 100 times higher than that of the a-Si TFTs; therefore, their use increases the pixel fill factor. However, LTPS TFTs exhibited a large degradation of the device performance in terms of threshold voltage ( V TH ) and subthreshold swing ( SS ) even under X-ray irradiation with low total doses of 0.87–4.35 Gy ascribed to the permanent damage to the crystalline structure of LTPS induced by X-ray radiation. − Recently, oxide TFTs have attracted considerable attention as backplanes for various flat-panel displays owing to their high carrier mobility, low processing temperature, and high uniformity. − Till date, only a few studies have examined the radiation tolerance of n-type oxide TFTs under X-ray irradiation. − However, the research results on the effects of X-ray irradiation on p-type oxide TFTs and oxide-TFT-based complementary metal–oxide–semiconductor (CMOS) logic circuits have not yet been reported. CMOS logic circuits using both n-type and p-type transistors exhibit rail-to-rail output voltage swings and high noise margins; , therefore, they can enhance the electrical performance of digital systems compared with n-type logic circuits.…”