No-Tension Sensor Closed-Loop Control Method with Adaptive PI Parameters for Two-Motor Winding System

Abstract

In a winding system, it is very important to control the tension precisely. Based on the process of rewinding and unwinding, a sensorless tension control method with PI parameters of adaptive speed controllers is proposed in this paper. According to the principle of torque balance, a tension observer is designed to replace the tension sensor, and the observed value instead of the measured value of tension is used as feedback. Then the measurement delay caused by tension sensor is reduced. For the time-variable inertia, Landau discrete-time recursive algorithm is used to estimate the inertias of the rewind and unwind motors. Moreover, the estimated inertias are used to adjust the PI parameters of the speed controllers. As the tension control system has the ability to adapt to the change of inertia, its dynamic performance is improved to some extent. In addition, the proposed sensorless tension control method is simple and easy to implement, which only uses the current and speed signals of the motors without any additional hardware needed. At last, the feasibility and effectiveness of the proposed method are verified by the experimental results.

A Novel Combining Method for Composite Groove Structure Fabrication

“…Filament winding is the main molding process for manufacturing rotary composite components [3]. It has the advantages of high forming efficiency, high forming quality and good mechanical properties when making the structure with rotary characteristics, and has shown great potential in improving the performance of composite materials and reducing production costs [4][5][6][7], so it is widely used in various fields of composite manufacturing.…”

Dynamics Modeling and Tension Control of Composites Winding System Based on ASMC

“…The synergetic decoupling control of transport speed and tension was performed combining with PI (proportionalintegral) and diagonal matrix decoupling control algorithm. In literature [13], a closed-loop control method of tensionless sensor with adaptive PI parameters is proposed. During the winding process, the measurement of tension by the tension sensor causes a measurement delay.…”

An Improved Electronic Line Shafting Control for Multimotor Drive System Based on Sliding Mode Observer

“…[1,2]. So far, the common control strategies of the multimotor drive system include master-slave control, cross coupling control, relative coupling control, and electronic line shafting (ELS) control [3][4][5][6][7].…”