Non-Self-Sustained Hollow-Cathode Glow Discharge at Low Burning Voltages

Денисов, В. В.; Akhmadeev, Yu. Kh.; Koval, N. N.; Lopatin, I. V.; Ostroverkhov, E. V.

doi:10.1007/s11182-019-01747-3

Cited by 1 publication

(1 citation statement)

References 5 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…One of the features of a hollow cathode discharge is the anomalously low value of the width of the cathode dark space and its weak dependence on the gas pressure [4], [9]. The width of the region of the cathode dark space in the plasma hollow cathode was measured using the curves of the radial distribution of the glow intensity.…”

Section: Eejp 2 (2021)mentioning

confidence: 99%

Influence of Electron Injection on the Characteristics of a Hollow Cathode Glow Discharge

2021

EEJP

View full text Add to dashboard Cite

The article presents the results of experimental studies of a glow discharge with a hollow cathode in helium and argon gases using an auxiliary discharge as an electron emitter. The authors proposed to make the electrode common for both discharges in the form of a cylindrical metal mesh. The advantage of this design is explained as follows. The connection between the discharges is carried out through holes in the grid with a geometric transparency of 0.2, which makes it possible not only to smoothly control the glow discharge current, but also to enhance the discharge current. Plasma is known to be one of the most efficient electron emitters; however, its use as a cathode in devices with a glow discharge at low gas pressures is complicated by the fact that a grid with small holes is required to separate the electron flow from the plasma, and it is impractical to use such a system in view of low mechanical strength of the grid Since the hollow cathode works effectively at low gas pressures, the release of an electron flux from the plasma of some auxiliary discharge is possible with much larger holes in the grid separating the plasma and the hollow cathode cavity. In this case, the grid can be made such that it can withstand sufficiently high thermal loads and can operate in typical discharge modes with a hollow cathode. The injection of electrons into the cathode cavity of the glow discharge changes the radial distribution of the glow intensity, the width of the cathode dark space, and other parameters of the plasma in the cathode cavity. The influence of electrons penetrating from the auxiliary discharge into the cathode cavity of the main discharge becomes significant when the current of these electrons is comparable to or exceeds the current of electrons leaving the grid cathode surface as a result of γ-processes. In parallel with the measurement of the optical and electrical characteristics of the hollow cathode glow discharge plasma, measurements of the electron concentration were carried out by the microwave sounding method. The entire current of the auxiliary discharge penetrates into the cavity of the main discharge; however, after acceleration in the cathode dark space, the electrons penetrating from the auxiliary discharge ionize gas atoms and noticeably increase the current of the main discharge. Additional ions formed due to the ionization of the gas by the injected electrons knock out new electrons from the cathode surface, which makes it possible to increase the discharge current.

show abstract

Section: Eejp 2 (2021)mentioning

confidence: 99%

Influence of Electron Injection on the Characteristics of a Hollow Cathode Glow Discharge

2021

EEJP

View full text Add to dashboard Cite

show abstract

Non-Self-Sustained Hollow-Cathode Glow Discharge at Low Burning Voltages

Cited by 1 publication

References 5 publications

Influence of Electron Injection on the Characteristics of a Hollow Cathode Glow Discharge

Influence of Electron Injection on the Characteristics of a Hollow Cathode Glow Discharge

Contact Info

Product

Resources

About