Numerical Investigation and Experimental Modal Analysis Validation to Mitigate Vibration of Induction Machine Caused due to Electrical and Mechanical Faults

Prasad, Kapu V Sri Ram; Singh, Varsha

doi:10.1007/s42835-022-01049-8

Cited by 11 publications

(1 citation statement)

References 23 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In some cases where there is a divergence between the fundamental frequency and the primary condition, the stator windings are susceptible to vibrate. This issue is raised due to looseness in the structure's robustness, which originates uneven vibration in the machine [3][4]. The resonance is reduced and the SW vibration may be overwhelmed if the fundamental frequency and induced electromagnetic force (emf) frequency are sufficiently different.…”

Section: Introductionmentioning

confidence: 99%

Induction Motor Structure Design to Reduce Vibrations With Numerical (FEA) and Experimental (VA) Techniques

Sri Ram Prasad,

Dhananjay Rao,

Alsaif

2024

IEEE Access

Self Cite

View full text Add to dashboard Cite

The resolution in the design of the machine structure can control vibrations that increase the lifespan of the induction motor (IM). This is feasible by retaining the machine's vibrations within acceptable ranges. To reduce these vibrations of an aged machine a vibration analyzer (VA), finite element approach (FEA), and experimental modal technique (EMT) are applied to an induction motor. The test on stator windings (SW) with global mode revealed that the windings in slots 7 and 8 are deformed. ANSYS software was used to model the machine with FEA numerically to predict the vibration velocity (VV) and found 18.3 mm/s. The vibration analysis was applied to IM and noticed a vibration velocity of 10.6 mm/s, indicating both the numerical and experimental vibration velocities are greater than 5 mm/s. This can reduce the reliability of the motor as per ISO Standard 10816 and cannot meet industrial needs. The test machine was numerically redesigned with a 6-hole reinforced frame and raised to 0.1 cm in thickness to reduce the vibrations then VV was recorded as 2.9 mm/s. Vibration analysis is carried out experimentally while the machine windings are tightened after modification and the vibration is 3.2 mm/s. Finally, both numerically (84.15%) and experimentally (69.81%), the test motor's vibrations are reduced, enhancing the test motor's reliability to meet industrial requirements and minimizing the plant's revenue cost.

show abstract

Section: Introductionmentioning

confidence: 99%