Numerical investigation of a vertical triplex‐tube latent heat storage/exchanger to achieve flexible operation of nuclear power plants

Abstract

The current numerical investigation is carried out to assess the possibility of integrating a latent heat thermal energy storage (TES) in a nuclear power plant (NPP) system. This would allow improving the capability of such plants to operate in a load-following mode by eliminating the gap between energy supply and energy demand by the grid. In contrary to previously published TES designs, the phase change material (PCM) triplex-tube containers are vertically oriented in the present study to take advantage of melting/solidification enhancements induced by the buoyancy forces. In addition, two different fluids simultaneously co-circulating within the storage, hence, allowing for this component to operate as a storage system (under extreme charging/discharging conditions) or as simple heat exchanger (under normal steady-state conditions). The computational domain, in this study, is reduced from the full TES geometry to a single triplextube container owing to the homogeneous triangular positioning of the annular tubes within the storage vessel. The results show that the time required to fully melt the solid PCM is around 27 hours during charging mode, thus, allowing for a relatively long-time margin even under an extreme postulated accident scenario consisting in the inability of the secondary loop to remove heat from the system. In the opposite discharging mode, the time needed to fully solidify the 100% liquid PCM is 17 hours. During the simultaneous charging and discharging (SCD) mode, with constant load, the fraction of liquid PCM is nearly fixed with time. Hence, TES in this mode is said to take the role of a standard heat exchanger. Finally, simulations conducted for the SCD mode, with variable load, demonstrate that the coupled system can follow the daily variations in the grid demand without having any significant impact on the constant operation of the reactor. In this operating mode, the PCM is changing phases from solid to liquid and vice versa to adapt to the energy demand variations as anticipated.

Dynamic Investigation of a Coupled Parabolic Trough Collector–Phase Change Material Tank for Solar Cooling Process in Arid Climates

“…It is interesting to note that the HTF temperature at the outlet of a control volume (i) is considered equal to the input temperature of the control volume (i + 1). The used convective heat transfer coefficient (h f ) is determined using the following equation [15,29]:…”

“…The use of phase change materials (PCMs) as a storage medium is advantageous for concentrated solar power technologies [13]. Mohamed Ali et al [14,15] have shown the potential of using the PCM tanks to reduce energy consumption and to overcome the problem of a mismatch between energy supply and energy demand. Recently, a solar cooling system using sensible thermal storage and evacuated tube collectors was proposed by Yadav et al [16].…”

Tools for modeling the level of harmonic distortion in power grids and their impact

“…Unfortunately, it is quite common for such devices to ignite, which leads to fires. In addition, when resonant phenomena occur, protective devices can be triggered, thereby reducing the reliability of the power supply (Bondarenko and Galich 2013;Ali et al 2022). Figure 16 presents graphs showing the connection of a capacitor device without throttles to a device.…”

An approximate analytical solution for the movement of the phase change front in latent thermal energy storage heat exchangers

“…The present paper focusses on LTES heat exchangers. LTES heat exchangers are developed in various geometries such as packed beds [9][10][11], corrugated plate heat exchangers [12], triplex tube heat exchangers [13], tube in tube heat exchangers [14] and perhaps most commonly shell and tube heat exchangers [15]. For all of these geometries, the design of the system first involves selecting a PCM material with an appropriate phase change temperature.…”