Numerical Investigation on Influence of Two Combined Faults and Its Structure Features on Rock Burst Mechanism

Abstract

With the increase in coal mining depth, engineering geological conditions and the stress environment become more complex. Many rock bursts triggered by two combined faults have been observed in China, but the mechanism is not understood clearly. The focus of this research aims at investigating the influence of two combined faults on rock burst mechanisms. The six types of two combined faults were first introduced, and two cases were utilized to show the effects of two combined faults types on coal mining. The mechanical response of the numerical model with or without combined faults was compared, and a conceptual model was set up to explain the rock burst mechanism triggered by two combined faults. The influence of fault throw, dip, fault pillar width, and mining height on rock burst potential was analyzed. The main control factors of rock burst in six models that combined two faults were identified by an orthogonal experiment. Results show that six combinations of two faults can be identified, including stair-stepping fault, imbricate fault, graben fault, horst fault, back thrust fault, and ramp fault. The particular roof structure near the two combined faults mining preventing longwall face lateral abutment pressure from transferring to deep rock mass leads to stress concentration near the fault areas. Otherwise, a special roof structure causing the lower system stiffness of mining gives rise to the easier gathering of elastic energy in the coal pillars, which makes it easier to trigger a rock burst. There is a nonlinear relationship between fault parameters and static or dynamic load for graben faults mining. The longwall face has the highest rock burst risk when the fault throw is between 6 and 8 m, the fault dip is larger than 65°, the mining height is greater than 6 m, and the coal pillar width is less than 50 m. The stair-stepping, imbricate, horst, and ramp fault compared to the other fault types will produce higher dynamic load stress during longwall retreat. Fault pillar width is the most significant factor for different two combined faults, leading to the rise of static load stress and dynamic proneness.

Optimization of Destressing Parameters of Water Jet Slits in Rock Burst Coal Seams for Deep Mining

“…It was on 20 October 2018 that a coal burst occurred in Longyun Coal Mine, in which the 174 m length long dip entry collapsed, associated with 21 workers being killed [6]. The other coal burst occurred on 9 June 2019 and was reported in the Longjiapu coal mine, resulting in the 220 m length roadway being damaged and injures to miners [7]. It was on 22 February 2020 that the coal burst occurred in the Xinjulong coal mine which also resulted in a huge loss [8].…”

Prediction of Grade Classification of Rock Burst Based on PCA-SSA-PNN Architecture

“…Rock burst is a kind of dynamic failure phenomenon which often occurs in the high ground stress area of deep buried tunnels. When the mechanical equilibrium state of rock mass is broken, the accumulated energy in the rock mass is released in a sudden and violent form, resulting in a dynamic instability phenomenon [1][2][3][4][5]. The accurate assessment of rock burst grade classification is an important content of rock burst prevention measures.…”

Numerical Simulation Study of the Effect of Fine View Pore Structure on Rock Burst

“…Physical experiments are undoubtedly the most direct method to study the relationship between pore structure characteristics and rock mechanical properties; however, the nonhomogeneity of the microstructure and the complexity of the pore structure in coal and rock masses prevent large-scale parametric investigations. In contrast, numerical techniques have been shown to be a powerful tool for studying the mechanics of sub-surface rocks [40].…”