Numerical Simulation of Welding Temperature Field, Stress Field, and Strain Field of Fillet Joint in Different Welding Sequence

Ye, Zhongzhao; Liu, Jianchun; Xie, Chao; Zhang, Shijie

doi:10.1088/1742-6596/2541/1/012003

Cited by 1 publication

(2 citation statements)

References 7 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In the context of thermal distribution, the temperature gradient near the welding heat source is minimal, resulting in rapid changes in the temperature field. Conversely, as one moves away from the center of the welding heat source, the temperature gradient becomes more pronounced, leading to a more gradual alteration in the temperature field (Ye et al, 2023).…”

Section: Analysis Methodsmentioning

confidence: 99%

See 1 more Smart Citation

Investigation of Effective Section Reduction in Low Carbon Steel during SMAW Welding

Mushthofa,

Pratama Nurfauzi,

Hardawati

2023

Teknisia

View full text Add to dashboard Cite

Welding, with its advantages of expedient execution and reduced weight, is a favored method for structural connections. However, it poses a significant risk, softening the steel and diminishing load-bearing capacity, underscoring the importance of accurate estimation. The need for precision is paramount, as critical infrastructure must remain operational not only during disasters but also during repair and maintenance activities. To address this challenge, this research introduces an approach to estimate the extent of capacity reduction resulting from welding, providing engineers with valuable insights for maintaining these critical systems structural integrity and functionality. The study examined low-carbon steel with various thicknesses, focusing on Heat Affected Zone (HAZ) width calculations and Abaqus simulations. Welding was performed at a speed of 1.67 cm/s with a 5 mm element increment. This research aimed to investigate the impact of welding parameters on low-carbon steel, particularly concerning HAZ measurements. A 4 mm-thick plate generated a 38.73 mm affected zone, while simulations with 5 mm to 12 mm thicknesses produced progressively narrower affected zones. Results demonstrated that steel plate thickness significantly influences the affected zone width, with thicker plates yielding narrower affected zones. The study examined low carbon steel with a 4 mm thickness, focusing on Heat Affected Zone (HAZ) width calculations and Abaqus simulations. Welding was performed at a speed of 1.67 cm/s with a 5 mm element increment. The research aimed to investigate the impact of welding parameters on low carbon steel, particularly concerning HAZ measurements. Results demonstrated that steel plate thickness significantly influences the affected zone width, with thicker plates yielding narrower affected zones. A 4 mm-thick plate generated a 38.73 mm affected zone, while simulations with 5 mm to 12 mm thicknesses produced progressively narrower affected zones.

show abstract

Section: Analysis Methodsmentioning

confidence: 99%

“…These residual stresses predominantly manifest both longitudinally and transversely. Notably, the magnitude of transverse residual stress is approximately one-third of the longitudinal residual stress (Ye et al, 2023). This study, however, exclusively focuses on the longitudinal direction, as transverse effects are disregarded.…”

Section: Stress During Weldingmentioning

confidence: 99%