On the mechanism of electron conductivity in lanthanum metaniobate

Pivovarova, A. P.; Strakhov, V. I.; Popov, V.

doi:10.1134/1.1519016

Cited by 12 publications

(3 citation statements)

References 3 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The electrical resistance of the obtained ceramic materials was measured by a twocontact method at direct current using the "Hardware-software installation for investigating the electrical properties of nanoceramics in different gas media" [26]. To provide electrical contact, silver electrodes were applied to the ends of the measured samples by annealing a silver conductive paste.…”

Section: Characterization Methodsmentioning

confidence: 99%

Effect of Synthetic Approaches and Sintering Additives upon Physicochemical and Electrophysical Properties of Solid Solutions in the System (CeO2)1−x(Nd2O3)x for Fuel Cell Electrolytes

et al. 2023

View full text Add to dashboard Cite

Finely dispersed (CeO2)1−x(Nd2O3)x (x = 0.05, 0.10, 0.15, 0.20, 0.25) powders are synthesized via liquid-phase techniques based on the co-precipitation of hydroxides and co-crystallization of nitrates. The prepared powders are used to obtain ceramic materials comprising fluorite-like solid solutions with the coherent scattering region (CSR) of about 88 nm (upon annealing at 1300 °C) and open porosity in the range of 1–15%. The effect of the synthesis procedure and sintering additives (SiO2, ZnO) on physicochemical and electrophysical properties of the resulting ceramics is studied. The prepared materials are found to possess a predominantly ionic type of electric conductivity with ion transfer numbers ti = 0.96–0.71 in the temperature range of 300–700 °C. The conductivity in solid solutions follows a vacancy mechanism with σ700 °C = 0.48 × 10−2 S/cm. Physicochemical properties (density, open porosity, type and mechanism of electrical conductivity) of the obtained ceramic materials make them promising as solid oxide electrolytes for medium temperature fuel cells.

show abstract

Section: Characterization Methodsmentioning

confidence: 99%

Effect of Synthetic Approaches and Sintering Additives upon Physicochemical and Electrophysical Properties of Solid Solutions in the System (CeO2)1−x(Nd2O3)x for Fuel Cell Electrolytes

et al. 2023

View full text Add to dashboard Cite

show abstract

“…The electrical resistance of the obtained ceramic materials was measured by a twocontact method using a direct current in the temperature range of 250-1000 • C and using the "Hardware-software installation to investigate the electrical properties of nanoceramics in different gas media" [28]. The transfer numbers of the ions and electrons in bulky solid electrolytes were determined by the West-Tallan method [29] using a CO 2 + CO mixture (corresponding to the oxygen partial pressure of 10 3 Pa) as an inert gas. The measurements were carried out using a direct current in weak (U = 0.5 V) fields after a long (up to 30 min) drop of the current.…”

Section: Characterization Methodsmentioning

confidence: 99%

Comparative Study of Physicochemical Properties of Finely Dispersed Powders and Ceramics in the Systems CeO2–Sm2O3 and CeO2–Nd2O3 as Electrolyte Materials for Medium Temperature Fuel Cells

et al. 2023

View full text Add to dashboard Cite

Finely dispersed (CeO2)1−x(Sm2O3)x (x = 0.05, 0.10, 0.20) and (CeO2)1−x(Nd2O3)x (x = 0.05, 0.10, 0.15, 0.20, 0.25) powders were synthesized via liquid-phase techniques based on the co-precipitation of hydroxides and were used to obtain ceramic materials comprising fluorite-like solid solutions with CSR in the range 69–88 nm (upon annealing at 1300 °C) and open porosity in the range 0.6–6.2%. The physicochemical properties of the synthesized materials were comparatively characterized. In general, the prepared materials were found to possess a mixed type of electrical conductivity, but in the medium-temperature range, the ionic component was predominant (ion transfer numbers ti = 0.93–0.73 at 300–700 °C). The highest ionic conductivity was observed for CeO2-based samples containing 20 mol.% Sm2O3 (σ700°C = 3.3 × 10−2 S/cm) and 15 mol.% Nd2O3 (σ700°C = 0.48 × 10−2 S/cm) was in the temperature range 500–700 °C. The physicochemical properties (density, open porosity, type and mechanism of electrical conductivity) of the obtained ceramic materials make them promising as solid oxide electrolytes for medium temperature fuel cells.

show abstract

“…The transfer numbers of ions and electrons in bulk solid electrolytes [17] were determined using the West-Tallan method. A mixture of CO 2 + CO was used as an inert gas (corresponding to a partial pressure of oxygen 10 3 Pa).…”

Section: Characterization Techniquesmentioning

confidence: 99%

Synthesis and Investigation of Ceramic Materials for Medium-Temperature Solid Oxide Fuel Cells

Калинина¹,

Dyuskina²,

Polyakova³

et al. 2022

Smart and Advanced Ceramic Materials and Applications

View full text Add to dashboard Cite

Finely dispersed (СeO2)1-x(Sm2O3)x (x = 0.02; 0.05; 0.10); La1-xSrxNiO3, La1-xSrxCoO3 and La1-xSrxFe0.7Ni0.3O3 (x = 0.30; 0.40) mesoporous xerogel powders are synthesized by co-crystallization of the corresponding nitrates with ultrasonic processing and used to obtain nanoscale ceramic materials with cubic fluorite-like, orthorhombic, and perovskite-like tetragonal crystal structure, respectively, with CSR ∼ 64–81 nm (1300°C). Physicochemical characterization of the obtained ceramics revealed that (СeO2)1-x(Sm2O3)x features with open porosity 2–6%, while for La1-xSrxNiO3, La1-xSrxCoO3, and La1-xSrxFe0.7Ni0.3O3, this value is about 21–29%. Ceria-based materials possess a predominantly ionic conductivity (ion transport numbers ti = 0.82–0.71 in the temperature range 300–700°C, σ700°С = 1.3·10−2 S/cm) determined by the formation of mobile oxygen vacancies upon heterovalent substitution of Sm3+ for Се4+. For solid solutions based on lanthanum nickelate and cobaltite, a mixed electronic-ionic conductivity (σ700°С = 0.80·10−1 S/cm) with ion transport numbers (te = 0.98–0.90, ti = 0.02–0.10) was obtained. The obtained ceramic materials are shown to be promising as solid oxide electrolytes and electrodes for medium-temperature fuel cells.

show abstract

On the mechanism of electron conductivity in lanthanum metaniobate

Cited by 12 publications

References 3 publications

Effect of Synthetic Approaches and Sintering Additives upon Physicochemical and Electrophysical Properties of Solid Solutions in the System (CeO2)1−x(Nd2O3)x for Fuel Cell Electrolytes

Effect of Synthetic Approaches and Sintering Additives upon Physicochemical and Electrophysical Properties of Solid Solutions in the System (CeO2)1−x(Nd2O3)x for Fuel Cell Electrolytes

Comparative Study of Physicochemical Properties of Finely Dispersed Powders and Ceramics in the Systems CeO2–Sm2O3 and CeO2–Nd2O3 as Electrolyte Materials for Medium Temperature Fuel Cells

Synthesis and Investigation of Ceramic Materials for Medium-Temperature Solid Oxide Fuel Cells

Contact Info

Product

Resources

About