On the Stability Analysis of Active Magnetic Bearing With Parametric Uncertainty and Position Tracking Control

Journal of Vibration and Control

Inoue

2018

Self Cite

In this paper, an optimal controller design method is proposed to compensate for vibrations caused by unbalanced force in the rotor system. The vibrations caused by unbalanced force are the major root cause of excessive whirling vibration in the rotor system, and it is important to compensate for the vibration to maintain its stable operation. The proposed design method can optimize a performance of the controller based on the vector locus of open loop characteristics on the Nyquist diagram. To verifiy the effectiveness, the proposed design method was employed for three typical active vibration control methods. The experimental results show that the proposed method can design the optimal parameters to compensate for the whirling vibrations of the rotor system.

Section: Dynamics Of the Experimental Systemmentioning

confidence: 98%

Development of optimal controller design method to compensate for vibrations caused by unbalanced force in rotor system based on Nyquist diagram

Journal of Vibration and Control

Inoue

2018

Self Cite

Development of a Measurement System for Analyzing Periodic External Forces Acting on Rotating Machineries

Journal of Dynamic Systems, Measurement, and Control

Inoue

2019

In this study, a measurement system is developed to analyze periodic external forces acting on a rotating machinery. The dynamics of a rotating machineries are influenced by various periodic external forces such as unbalanced forces, oil film forces at a journal bearing, and seal contact forces. The characteristics of periodic external forces are dependent on the rotating conditions, rotational speed, and rotating orbit of the rotating shaft. The proposed system employs an active magnetic bearing (AMB), which is implemented using an adaptive feed-forward cancellation (AFC). The use of AFC ensures that the proposed system can realize the desired harmonic orbit assuming actual operations under the periodic external forces. Moreover, AFC can measure the periodic external forces in real-time using an adaptive algorithm. The effectiveness of the proposed system is verified experimentally. Experimental results show that the control system can control the rotating shaft to an accuracy of micrometer order using the implemented AFC. The measurement error of the periodic external forces acting on the rotating system is less than 2%.

Development of magnetic bearing device for analysing external forces in arbitrary trajectory to rotor system

Kato

Transactions of the JSME (In Japanese)

Takagi

et al. 2018

In design of rotating machines, analysis of external force is important for stable rotating operation. The various external forces such as unbalance force, seal contact force and rotor dynamic fluid force effect on the rotor system, dynamic characteristics of rotating system is changed by the external forces. The external force can vary depending on a rotor trajectory. In previous studies, a mathematical model of the dynamic characteristics had been formulated for small amplitude orbit around the equilibrium point for the rotor trajectory. However, the formulation hasn't been yet established in the rotor trajectory with large amplitude or eccentricity caused by the external forces. In this study, an experimental system using active magnetic bearing (AMB) is developed to achieve the formulation. The system can generate any arbitrary trajectory assuming various external forces and the rotor system follow the generated trajectory. The system can estimate the external force at the same time. Current flowing through coil of the AMB is controlled by a controller designed based on the frequency response to follow the arbitrary orbit. Then, the external forces are estimated from the control signal by the disturbance observer. Experiments were performed by assuming unbalance forces generated in the elastic rotor. From the results it was confirmed experimentally that high precision tracking control and estimation of external force are possible. The various rotor trajectory under the action of the external forces can be repeated by using the system, and the external force can be analyzed by the experimental data.