2018
DOI: 10.1016/j.ijthermalsci.2018.04.033
|View full text |Cite
|
Sign up to set email alerts
|

Optimization of finned solar photovoltaic phase change material (finned pv pcm) system

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
3
1
1

Citation Types

1
34
0
1

Year Published

2018
2018
2024
2024

Publication Types

Select...
6
3

Relationship

3
6

Authors

Journals

citations
Cited by 161 publications
(36 citation statements)
references
References 40 publications
1
34
0
1
Order By: Relevance
“…The optimum values for the liquification temperature of PCM have been reported for PV-PCM and PVT-PCM systems by Park et al (2014) and Su et al (2017) respectively. Khanna et al (2018aKhanna et al ( , 2018b) have investigated the impact of climates on the contribution of PCM in PV cooling and carried out the optimization (Khanna et al, 2018c;2018d;2019). Arici et al (2018) have also carried out the optimization of PV-PCM system.…”
Section: Literature Reviewmentioning
confidence: 99%
“…The optimum values for the liquification temperature of PCM have been reported for PV-PCM and PVT-PCM systems by Park et al (2014) and Su et al (2017) respectively. Khanna et al (2018aKhanna et al ( , 2018b) have investigated the impact of climates on the contribution of PCM in PV cooling and carried out the optimization (Khanna et al, 2018c;2018d;2019). Arici et al (2018) have also carried out the optimization of PV-PCM system.…”
Section: Literature Reviewmentioning
confidence: 99%
“…Despite the maximum temperature value (section 1), the single layer MLM heat sink is considered to be the most temperature variable around the heat source (sections 2-9) with a standard deviation of 4.30 °C. Interestingly, two-layers MLM heat sinks experiences less temperature non-uniformity compared to the three-layers MLM heat sink with a standard deviation of 3 Further investigation on the temperature uniformity on the heat source top surface temperature was conducted. Figure 9 shows the measured temperature distributions of the surface of the heat source in nine sections for the different number of layers heat sinks.…”
Section: Effects Of Number Of Layersmentioning
confidence: 99%
“…Concentrating photovoltaic (CPV) technology has gained much more attention than the conventional photovoltaic due its competitive cost [1]. Eighty percent of the concentrated sunlight is absorbed by the solar cell, only a small portion is converted to electrical energy, and the remaining is converted to thermal energy which causes an increase of the solar cell temperature [2,3]. A study showed that the solar cell temperature could reach 1400 • C under 500 concentration ratio if it is fully insulated [4].…”
Section: Introductionmentioning
confidence: 99%
“…Thin aluminium is difficult to weld because of its melting temperature, which is lower than other metals. During sunny days, PCM changes its phase and, considering this phase change, PCM container is fabricated in the thickness of 4-8 mm metal [32][33][34][35][36]. In T PV reduction, low operating PCM temperature is used, which is sensitive in thermal conduction whenever the thickness of PCM container material increases.…”
Section: Introductionmentioning
confidence: 99%