Optimization of material removal rate and surface roughness during electric discharge machining of ultra‐fine grained Al6082 using Taguchi technique

Abstract

In the current work, the statistical analysis of various electric discharge machining parameters on Al6082 ultra‐fine grained aluminium alloy using Taguchi method has been presented. Repetitive corrugation and straightening (RCS) method was employed to obtain ultra‐fine grained aluminium alloy. The electric discharge machining studies were carried out for test variables – pulse off time, pulse on time and current (I). The specimens were machined in dielectric medium with current range of 3 A to 9 A in step of 3 A. Machining features of the samples analysed statistically by adopting the Taguchi's ‐ design of experiments (DOE) methodology. Impact of parameters on material removal rate (MRR) and surface roughness (SR) were examined via signal‐to‐noise ratio (S/N ratio, expressed in decibel, dB) as well as analysis‐of‐variance (ANOVA). Outcomes disclose that every selected response explicitly surface roughness (SR) and material removal rate was significantly influenced by parameters. The material removal rate was found to rise with discharge current and decrease with the duration of pulse on time and the duration of pulse off time. On the other hand, the surface roughness increased with increase in peak current and decreased with pulse on time and pulse off time especially. The machining mechanisms were examined by scanning electron microscopy.