Optimization of Nd-Doped LMA Fibers for High-Power Laser Emission Near 915 nm

Abstract

We report on the development of low numerical aperture (NA) Nd-doped large mode area (LMA) fibers with optimized core/clad geometry to achieve high-power laser emission near 915 nm while maintaining near diffraction-limited output beam. The influence of clad-to-core ratio on the detrimental amplified spontaneous emission (ASE) at 1050 nm and on the beam quality was studied experimentally in different amplifier configurations. We also show that bending the Nd-doped LMA fiber to a precise radius of curvature significantly improves the overall laser performances of these fibers by limiting both higher-order modes and spurious ASE at 1050 nm. The possibility of all-fiber multi-stages amplifier configurations with diffraction-limited output beam is finally discussed.

Review of High-Power Continuous Wave Yb-Doped Fiber Lasers near 980 nm

“…Increasing the wavelength diversity is one important motivation driving the development of fiber lasers, because it can expand the applications of fiber lasers. Nowadays, various rear-earth-doped fibers are presented and studied to increase the wave-length diversity, e.g., Er-doped [10,11], Yb-doped [12,13], Nd-doped [14,15], Tm-doped [16,17], and Ho-doped [18,19] fibers, which extend the wavelength from the infrared to the midinfrared region. The Yb-doped fiber laser near 980 nm is just one prospective topic among the pertinent studies.…”