Parameters of tillage working bodies

Abstract

This article notes that most of the soil-cutting working bodies wear out their socks a lot, as a result of which their limiting state is reached. Despite the fact that other parts of the working body are still workable and the stock of metal for wear is still sufficient, the working body is completely rejected. In this regard, it is emphasized that increasing the durability of the nose parts leads to an increase in the durability of the entire working body. To determine its parameters, the condition for leveling the resources of socks and other parts of the soil-cutting working bodies is considered. When determining the length of the nose of the bits, an analytical dependence is recommended, taking into account the geometric parameters of the bit and the plowshares welded to it. To obtain self-sharpening in the process of bit nose wear, it is recommended to use a new two-faceted profile. The rational values of the length, the angle of the wedge and the sharpening of the nose are determined, equal to 90 mm, 100 and 350-400, respectively. Based on the condition of rational combinations of strength and self-sharpening characteristics of the toes of bits, the thickness and width of the latter were determined, equal to 22.3 mm and 30 mm, respectively.

Mathematical model of water drop trajectory in artificial rainfall

“…Today, in Uzbekistan, drip irrigation has been introduced on 198.9 hectares, discrete irrigation systems on 5.9 hectares, 78.8 hectares are irrigated through portable, flexible pipes, and 20.9 hectares are irrigated using film. In comparison, artificial sprinkler irrigation method was introduced on 11.2 thousand hectares [17][18][19][20][21][22][23][24][25][26][27][28][29][30][31][32][33][34][35]. This is about 2.1% of the area where efficient irrigation technologies have been introduced.…”