South Kalimantan-Indonesia is known to have extensive peatlands reaching 15% of a total peatland in Kalimantan. Due to that peat land water is mostly found and claim as abundant water sources. However, based on quality, peat land water has poor characteristic with high natural organic matter content. Therefore, peat water treatment is necessary to treat using effective method such as hybrid conventional filter and membrane using hollow fibre PVDF-TiO2/SBE. This study aims to investigate the variation of media filter thickness and filtration pressure of hollow fibre (HF) PVDF-TiO2/SBE membrane peat water treatment by filtration pre-treatment and HF membrane ultrafiltration. HF PVDF-TiO2/SBE membrane was prepared by wet spinning method using spinneret set up. Hybrid process was divided into two steps: 1) conventional filter as pre-treatment and 2) HF ultrafiltration membrane under cross flow system. The filter media was used in this work is silica sand and activated carbon with varied thickness 30:10 and 10:30 cm. The HF membrane structure was analysed via scanning electron microscopy (SEM) to investigate the membrane morphology. The results show the fabricated HF membrane has a finger like-sponge sandwich structure morphology. In addition, 30:10 cm (silica sand: activated carbon) thickness exhibits TDS and turbidity removal of 92.18 and 61.37%, respectively as conventional filter pre-treatment. In other hand, HF membrane successfully removed TDS and turbidity of peat water up to 98.68% and 92.41% at 2 bar of filtration pressure. The highest permeate flux of HF membrane conducted of 13.055 Kg.m-2.h-1 at 3 bar. Conclusion of this work is the peat water treatment using activated carbon: silica filtration pre-treatment and HF membrane ultrafiltration can provide clean water with maximum turbidity and TDS removal.