Performance evaluation of thermoelectric generator employing SEPIC converter and incremental conductance maximum power point tracking for electric vehicles

Jaswanth, N.; Dheep, G. Raam

doi:10.1088/1742-6596/2327/1/012005

Cited by 2 publications

(3 citation statements)

References 9 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The time domain analysis of the fourth-order system concerning reduced-order system response has been analyzed. The impact of I L1 input current with V C2 output capacitor voltage in reduced order is generalized as a negligible effect of I L2 output inductor current and V C1 coupling capacitor voltage [10,[35][36][37][38][39][40].…”

Section: ´´-´´+mentioning

confidence: 99%

See 1 more Smart Citation

Optimized virtual impedance solar restoration droop emulated SEPIC controller under low irradiation

Yadav,

Singh

2024

Eng. Res. Express

View full text Add to dashboard Cite

This paper is focused on PV-based reduced order pade’s approximation SEPIC virtual impedance, restoration controller with parallel impedance emulation condition. However, the complexity of the higher-order SEPIC controller has been reduced and compared by Pade’s approximation with different reduction techniques. It covers the time response, oscillation, overshoot, dynamic performance and stability of the controller. The computational time and need of the sensor are less and occur better response compared to the other reduction technique under the solar irradiance variation. However, in PV, the dynamic resistance is generalized by nonlinear solar I-V curve dependent on the operating point as irradiance, temperature and its I-V curve. The non-linearity effect affectsthe stability of the system. TheSEPIC outer voltage and inner current controller with virtual impedance controller is used to enhance the stability, and comparative response demonstrated through the bode plot. A virtual impedance controller (VIC) cascaded with voltage restoration is used to minimize the voltage notching and oscillations under variation of inertia coefficients. The transient and dynamic performance of reduced order using a genetic algorithm controller has been used to demonstrate and discuss the PV-SEPIC system's stability.

show abstract

Section: ´´-´´+mentioning

confidence: 99%

“…When the parallel Impedance is set, the approximate equivalent Impedance Z eq can be calculated by equation (39), and the bode diagram is demonstrated in figure 6.…”

Section: Reduced Order Parallel Impedance Emulation-based Voltage And...mentioning

confidence: 99%

Optimized virtual impedance solar restoration droop emulated SEPIC controller under low irradiation

Yadav,

Singh

2024

Eng. Res. Express

View full text Add to dashboard Cite

show abstract

“…Cross-region power exchange is significant in effective management of power demand with renewable energy integration [6]. Maximum power tracking (MPT) algorithms are efficient in optimizing solar energy into the power system [7][8]. Simple block representation of smart grid is given in Fig.…”

Section: Introductionmentioning

confidence: 99%

Modelling of an Interconnected Power System using Solar-Wind Energy Integration

Kumar,

Agrawal,

Kumar

et al. 2024

IOP Conf. Ser.: Earth Environ. Sci.

View full text Add to dashboard Cite

This paper revolves around the modification and improvement required for increasing the efficiency of the power generation and distribution system. As the demand for electricity and power consumption is increasing day by day, more efficient and capable system is required to reduce the burden and complicatedness of the power grid. The transformation or conversion of conventional power grid to smart grid which contains number of actuators, sensors and transducers which provides ability to control, analyse and maintain the grid which provides support for various types of new loads that are introducing in current period. Along with that, the involvement and guidance of the human element is also increasing rapidly in the power generation and distribution station. This involvement allows the monitoring, analysing, and recording the information to be done more precisely with less factors of error. Based on this, the simulation and integration of renewable energy sources simulated through MATLAB/Simulink reduces the burden on non-renewable source of energies such as Coal, Fuel, etc. Although it will be impossible to replace these sources completely but integrating such sources along with smart grid will allow to monitor and share information regarding the grid and its performance much efficiently. The data shared from smart grid plays a valuable role in estimation energy consumption and what may the demand in the future.

show abstract

Performance evaluation of thermoelectric generator employing SEPIC converter and incremental conductance maximum power point tracking for electric vehicles

Cited by 2 publications

References 9 publications

Optimized virtual impedance solar restoration droop emulated SEPIC controller under low irradiation

Optimized virtual impedance solar restoration droop emulated SEPIC controller under low irradiation

Modelling of an Interconnected Power System using Solar-Wind Energy Integration

Contact Info

Product

Resources

About