Piezoelectric acoustic pressure sensor diaphragm design for energy harvesting

Hegde, Vasudha; Veena, S.; Ravikumar, H. M.; Yellampalli, Siva

doi:10.1109/icaect.2014.6757055

Cited by 6 publications

(1 citation statement)

References 2 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Existing AEH technologies largely suffer from two main limitations: size and bandwidth. Existing approaches predominantly rely on MEMS-scale devices, with collection areas of square millimeters or smaller [10,[12][13][14][15][16]. Because incident acoustic energy is proportional to collection size, such small devices are extremely limited in their potential for harvesting energy.…”

Section: Introductionmentioning

confidence: 99%

Broadband, large scale acoustic energy harvesting via synthesized electrical load: I. Harvester design and model

Monroe

Lang

2019

Smart Mater. Struct.

View full text Add to dashboard Cite

With the rise of Internet-of-Things and connected devices, the need for self-powered wireless sensor nodes is ever increasing. One promising technology for self-powered sensor nodes in noisy environments is acoustic energy harvesting: deriving energy from ambient sound. Existing acoustic energy harvesters are typically based on resonant structures, yielding narrowband, and therefore low-energy, collection from broadband noise sources. In addition, existing acoustic energy harvesters tend to exhibit MEMS-scale sizes, with consequently low power outputs. This two-part work addresses the size and bandwidth of such harvesters. A large-scale acoustic energy harvester is developed, based on piezoelectric PVDF (polyvinylidene fluoride) film 100 cm 2 in size. The harvester is designed to minimize reactive impedance, allowing for circuit loading for broadband energy harvesting in Part II of this paper. An energy-based dynamic analysis of the harvester driven by an acoustic source yields an equivalent circuit model and subsequently a Thévenin equivalent model of the harvester. The model is validated by experiments including acoustic and electric measurements, laser Doppler vibrometry, and finite element analysis. It is used to develop loadings in Part II.

show abstract