Polymeric Material Application for The Production of Ceramic Foam Catalyst

Sangsuriyan, Anucha; Yeetsorn, Rungsima; Tungkamani, Sabaithip; Sornchamni, Thana

doi:10.17703/ijact.2015.3.1.21

Cited by 1 publication

(1 citation statement)

References 13 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The H 2 percentage yields of 100CF-10NAM/PU_2.0 °C/min were considerably higher than the theoretical value that may be caused by side reactions producing hydrogen and carbon dioxide, for example, the decomposition of CH 4 and disproportionation of CO, as shown in eqs 1 and 2, respectively. 71…”

Section: ■ Results and Discussionmentioning

confidence: 99%

Fabrication of a Ceramic Foam Catalyst Using Polymer Foam Scrap via the Replica Technique for Dry Reforming

2022

Self Cite

View full text Add to dashboard Cite

Megapores with spherical-like cells connected through windows and high porosities make up catalyst supports in the form of ceramic foams. These characteristics provide significant benefits for catalytic processes that are limited by mass or heat transport. This study focuses on the manufacture of ceramic foam using a polymeric sponge replica process and polymer foams as a template for catalyst supports, which are industrial waste from the packaging sector. To make ceramic foam catalysts, they were dipped in a catalyst solution, followed by a breakdown stage and a sintering process. Experiments focused on determinants that affect the desired characteristics of ceramic foams, such as the types of polymer foams that affect foam morphology, the rheology of catalyst solution that affects catalyst dispersion, and the polymer decomposition rate that affects catalytic performance during dry reforming of the methane process. The cell architectures of polyurethane and polyvinyl alcohol foams are attractive for catalyst support preparation because they have 98−99% porosity and typical cell sizes of 200 and 50 μm, respectively. The polyurethane performance was superior to the performance of polyvinyl alcohol in terms of higher porosity and better catalytic-solution absorption offering high catalyst active areas. The catalyst prepared from concentrated 10 wt % Ni/Al 2 O 3 −MgO (10NAM) slurry had the highest surface area (59.18 m 2 /g) and the highest metal oxide dispersion (5.65%). These results are relevant to the flow behavior of catalyst slurry which plays a key role in coating the catalyst gel on the polymer template. The thermal decomposition rate used to remove the polymer template from the catalyst structure is proportional to the ceramic foam structure (catalyst support structure). The slow decomposition rate bent and fractured foam-cell struts more than the faster rate. On the other hand, achieving good catalyst dispersion on catalyst supports necessitated a high sintering rate. When sintering was adjusted at a high sintering rate, the metal− particle dispersion was relatively high, around 7.44%, and the surface area of ceramic foam catalysts was 64.61 m 2 /g. Finally, the catalytic behavior toward hydrogen production through the dry reforming of methane using a fixed-bed reactor was evaluated under certain operating conditions.

show abstract

Section: ■ Results and Discussionmentioning

confidence: 99%