Porous Photocatalytic Membrane Microreactor (P2M2): A new reactor concept for photochemistry

Aran, H.C.; Salamon, David; Rijnaarts, Timon; Mul, Guido; Weßling, Matthias; Lammertink, Rob G.H.

doi:10.1016/j.jphotochem.2011.09.022

Cited by 63 publications

(40 citation statements)

References 33 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…201 A porous photocatalytic membrane microreactor was built and applied for various photooxidation reactions. The reactor was microfabricated (CNC milling) from porous aluminium oxide (α-Al2O3).…”

Section: Homogeneous Catalysismentioning

confidence: 99%

Liquid phase oxidation chemistry in continuous-flow microreactors

et al. 2016

View full text Add to dashboard Cite

Continuous-flow liquid phase oxidation chemistry in microreactors receives a lot of attention as the reactor provides enhanced heat and mass transfer characteristics, safe use of hazardous oxidants, high interfacial areas, and scale-up potential. In this review, an up-to-date overview of both technological and chemical aspects of liquid phase oxidation chemistry in continuous-flow microreactors is given. A description of mass and heat transfer phenomena is provided and fundamental principles are deduced which can be used to make a judicious choice for a suitable reactor. In addition, the safety aspects of continuous-flow technology are discussed. Next, oxidation chemistry in flow is discussed, including the use of oxygen, hydrogen peroxide, ozone and other oxidants in flow. Finally, the scale-up potential for continuous-flow reactors is described.

show abstract

Section: Homogeneous Catalysismentioning

confidence: 99%

Liquid phase oxidation chemistry in continuous-flow microreactors

et al. 2016

View full text Add to dashboard Cite

show abstract

“…This is especially critical when a large-scale array of microfluidic channels is required [4]. For example, previous reports on microfluidic photocatalytic devices used clean-room techniques to fabricate the mold for the microfluidic device [14,3,6] or to pattern the photocatalyst substrate [2] or CNC milling to pattern the substrate [19]. In contrast, in this study the microreactor mold was fabricated using laser patterned polymethyl methacrylate (PMMA) sheets [20,21] and polydimethylsiloxane (PDMS) was used to fabricate the device.…”

Section: Introductionmentioning

confidence: 99%

Anodized titania nanotube array microfluidic device for photocatalytic application: Experiment and simulation

Jayamohan

Smith

Hansen

et al. 2015

Applied Catalysis B: Environmental

View full text Add to dashboard Cite

“…Many different types of photocatalytic reactors were developed but the reactors demonstrate either good mass transfer or good photon transfer but not often both [9,10]. Research to achieve higher mass transfer has resulted in significant advances with spinning disk reactors [11], monolith reactors [12] and micro-reactors [13,14].…”

Section: Introductionmentioning

confidence: 99%