Potentiometric determination of free acidity in presence of hydrolysable ions and a sequential determination of hydrazine

Ganesh, S.; Khan, Fahmida; Ahmed, M.K.; Pandey, S. K.

doi:10.1016/j.talanta.2011.05.001

Cited by 27 publications

(11 citation statements)

References 29 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Previously reported techniques for the detection of hydrazine include spectrophotometry [6], fluorimetry [7,8], chemiluminescence [9] and potentiometry [10,11]. However, all these methods are accompanied by several disadvantages like low sensitivity, and they require expensive instrumentation followed by complicated procedures.…”

Section: Introductionmentioning

confidence: 99%

Iron-Doped Titanium Dioxide Nanoparticles As Potential Scaffold for Hydrazine Chemical Sensor Applications

et al. 2020

View full text Add to dashboard Cite

Herein, we report the fabrication of a modified glassy carbon electrode (GCE) with high-performance hydrazine sensor based on Fe-doped TiO 2 nanoparticles prepared via a facile and low-cost hydrothermal method. The structural morphology, crystalline, crystallite size, vibrational and scattering properties were examined through different characterization techniques, including FESEM, XRD, FTIR, UV-Vis, Raman and photoluminescence spectroscopy. FESEM analysis revealed the high-density synthesis of Fe-doped TiO 2 nanoparticles with the average diameter of 25 ± 5 nm. The average crystallite size of the synthesized nanoparticles was found to be around 14 nm. As-fabricated hydrazine chemical sensors exhibited 1.44 µA µM −1 cm −2 and 0.236 µM sensitivity and limit of detection (LOD), respectively. Linear dynamic ranged from 0.2 to 30 µM concentrations. Furthermore, the Fe-doped TiO 2 modified GCE showed a negligible inference behavior towards ascorbic acid, uric acid, glucose, SO 4 2− , NO 3 − , Pb 2+ and Ca 2+ ions on the hydrazine sensing performance. Thus, Fe-doped TiO 2 modified GCE can be efficiently used as an economical, easy to fabricate and selective sensing of hydrazine and its derivatives.

show abstract

Section: Introductionmentioning

confidence: 99%

Iron-Doped Titanium Dioxide Nanoparticles As Potential Scaffold for Hydrazine Chemical Sensor Applications

et al. 2020

View full text Add to dashboard Cite

show abstract

“…6 The methods reported in the literature for estimating the free acidity are based on alkalimetric titration after complexing the heavy metal ion or removing the metal ion from the solution using an ion-exchange technique. 7,8 In reprocessing plants, corrosive chemicals such as sulfate, fluoride, oxalate and thiocyanate are employed as complexing agents for heavy metal ions in the routine analysis of plant samples during the free acidity determination.…”

Section: Introductionmentioning

confidence: 99%

Sequential Determination of Free Acidity and Plutonium Concentration in the Dissolver Solution of Fast-Breeder Reactor Spent Fuels in a Single Aliquot

Dhamodharan

Pius

2016

ANAL. SCI.

View full text Add to dashboard Cite

A simple potentiometric method for determining the free acidity without complexation in the presence of hydrolysable metal ions and sequentially determining the plutonium concentration by a direct spectrophotometric method using a single aliquot was developed. Interference from the major fission products, which are susceptible to hydrolysis at lower acidities, had been investigated in the free acidity measurement. This method is applicable for determining the free acidity over a wide range of nitric acid concentrations as well as the plutonium concentration in the irradiated fuel solution prior to solvent extraction. Since no complexing agent is introduced during the measurement of the free acidity, the purification step is eliminated during the plutonium estimation, and the resultant analytical waste is free from corrosive chemicals and any complexing agent. Hence, uranium and plutonium can be easily recovered from analytical waste by the conventional solvent extraction method. The error involved in determining the free acidity and plutonium is within ±1% and thus this method is superior to the complexation method for routine analysis of plant samples and is also amenable for remote analysis.

show abstract

“…Because of the great importance of hydrazine, its accurate and economical determination is still a challenging research in analytical chemistry. Several instrumental methods for the determination of hydrazine by flow injection analysis with fluorimetric (Ensafi and Rezaei 1998), chemiluminescence detection (Huang et al 1999), optical chemicalsensors (Gojon et al 1999), potentiometric (Ganesh et al 2011), spectrophotometric (George et al 2007), chromatography (Mori et al 2004), and capillary electrophoresis (Siangproh et al 2005) methods have been described in the literature.…”

Section: Introductionmentioning

confidence: 99%

Fabrication of novel TiO2 nanoparticles/Mn(III) salen doped carbon paste electrode: application as electrochemical sensor for the determination of hydrazine in the presence of phenol

Mahmoudi–Moghaddam

Beitollahi

Tajik

et al. 2015

Environ Monit Assess

View full text Add to dashboard Cite

Hydrazine and phenol are two important environmental pollutants. In this work, an electrochemical sensor for the selective and sensitive detection of hydrazine in presence of phenol was developed by the bulk modification of carbon paste electrode (CPE) with TiO2 nanoparticles and Mn(III) salen. Large peak separation, good sensitivity, and stability allow this modified electrode to analyze hydrazine individually and simultaneously along with phenol. Applying square wave voltammetry (SWV), a linear dynamic range of 3 × 10(-8)-4.0 × 10(-4) M with detection limit of 10.0 nM was obtained for hydrazine. Finally, the proposed method was applied to the determination of hydrazine and phenol in some real samples.

show abstract

Potentiometric determination of free acidity in presence of hydrolysable ions and a sequential determination of hydrazine

Cited by 27 publications

References 29 publications

Iron-Doped Titanium Dioxide Nanoparticles As Potential Scaffold for Hydrazine Chemical Sensor Applications

Iron-Doped Titanium Dioxide Nanoparticles As Potential Scaffold for Hydrazine Chemical Sensor Applications

Sequential Determination of Free Acidity and Plutonium Concentration in the Dissolver Solution of Fast-Breeder Reactor Spent Fuels in a Single Aliquot

Fabrication of novel TiO2 nanoparticles/Mn(III) salen doped carbon paste electrode: application as electrochemical sensor for the determination of hydrazine in the presence of phenol

Contact Info

Product

Resources

About