Power Conversion Enhancement of CdS/CdTe Solar Cell Interconnected with Tunnel Diode

Abstract

One of the most promising solar cell devices is cadmium telluride (CdTe) based. These cells however, have their own problems of stability and degradation in efficiency. Measurements show that CdS/CdTe solar cell has high series resistance which degrades the performance of solar cell energy conversion. Both active layers (CdS and CdTe) had been fabricated by thermal evaporation and tested individually. It was found that CdS window layer of 300 nm have the lowest series resistance with maximum light absorption. While 5 - 7 µm CdTe absorber layer absorbed more than 90% of the incident light with minimum series resistance. A complete CdS/CdTe solar cell was fabricated and tested. It was found that deposited cell without heat treatment shows that the short circuit current increment decreases as the light intensity increases. This type of deposited cell has low conversion efficiency. The energy conversion efficiency was improved by heat treatment, depositing heavily doped layer at the back of the cell and minimizing the contact resistivity by depositing material with resistivity less than 1 m??cm<sup>2</sup>. All these modifications were not enough because the back contact is non-ohmic. Tunnel diode of CdTe (p++)/CdS (n++) was deposited in the back of the cell. The energy conversion efficiency was improved by more than 7%

Boosting VOC of antimony chalcogenide solar cells: A review on interfaces and defects

“…As mentioned above, the free carrier concentration of undoped Sb 2 Se 3 and Sb 2 S 3 semiconductor on the level of 10 13 cm −3 , [152] were lower than conventional absorber materials, such as CdTe. [153,154] An ultrathin dielectric film such as TiO 2 , Al 2 O 3 are often used to passivate the surface defects in CZTSSe solar cells. [155][156][157] Inspired by this, a monoatomic Al 2 O 3 film was introduced as a passivation layer by an ALD method (Figure 14F).…”

CdS Nanoparticles: A Facile route to Size-Controlled Synthesis of Quantum Dots on a Polymer Matrix

“…The direct, wide energy band gap of CdS (about 2.4 eV. for bulk material) makes it a good candidate for using as a window layer in the second generation of solar cells [1,2].…”

Thermal annealing of sequentially deposited SnS thin films

“…Among these, solar radiation has the greatest potential because of its abundance. Materials such as CuInSe 2 [1], CuInS 2 [2], CdTe [3], and SnS [4] have been used as absorber layers in thin-film solar cells to convert solar radiation to electricity. For this SnS is very promising because of its high absorption coefficient (10 5 ), suitable bandgap for solar cells, and abundance in nature [5].…”