Power Supply of Oil Production Facilities Using Associated Petroleum Gas

Turysheva, Anna V.; Gulkov, Yuri V.; Baburin, Sergey N.

doi:10.1109/eiconrus49466.2020.9039526

Cited by 5 publications

(1 citation statement)

References 4 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…-It can be used for enhance oil recovery as re-injection gas [18][19]. According to the results of the investigations, the most beneficial methods for application are as follows: for volumes that exceed 0.1 billion m3/year, it is useful utilizing APG to provide local electricity generation; for volumes between the 0.1 and 0.5 billion m3/year, it's seems more possible for obtaining finished petrochemicals through the capabilities of gas refineries; and for volumes greater than 0.5 billion m3/year, it is beneficial to employ combined-cycle seeds and market the excess energy produced [20] [21].…”

Section: Uses Of Associated Petroleum Gasmentioning

confidence: 99%

Associated Petroleum Gas: Environmental, Utilization, and Economic Rationale

Al-Rubaye,

Jasim,

Jassam

et al. 2023

IOP Conf. Ser.: Earth Environ. Sci.

View full text Add to dashboard Cite

This study intends to shed light on associated gas from an economic standpoint, due to its various applications instead of oil, and from an environmental standpoint, due to the damage it does when burned during crude oil extraction. APG is a key raw material in the production of electricity and heating energy, as well as a variety of petrochemical products. Furthermore, APG has higher levels of water, which is known as wet gas, and hydrogen sulphide, which is known as sour gas. Helium, a marginally useful by-product, may be discovered in significant quantities. Different countries(Russia, Iraq, Iran, the US, Algeria, Venezuela, and Nigeria) have been the most prominent flare-ups over the past nine years. Also, these countries produced approximately 40% of the world’s oil per year, however they are also responsible for almost two-thirds (65%) of the world’s gas flaring. Flaring associated petroleum gas occurs for a variety of causes, which may be divided into difficult causes and soft causes. On another hand, When gas is flared, a considerable amount of pollutants are emitted. Flare stack smoke indicates an inefficient combustion process, which increases the volume of harmful pollutants generated into the surrounding environment, such as volatile organic compounds.

show abstract

Section: Uses Of Associated Petroleum Gasmentioning

confidence: 99%

Associated Petroleum Gas: Environmental, Utilization, and Economic Rationale

Al-Rubaye,

Jasim,

Jassam

et al. 2023

IOP Conf. Ser.: Earth Environ. Sci.

View full text Add to dashboard Cite

show abstract

The modeling and analysis of the parameters of the non-sinusoidal modes

Sychev

Prokhorova

Aladin

2021

J. Phys.: Conf. Ser.

View full text Add to dashboard Cite

The article is devoted to the analysis of the parameters of the non-sinusoidal modes. These parameters include the components of the total apparent power in the presence of the voltage and current harmonics such as the voltage distortion power, the current distortion power, the harmonic distortion power, the fundamental apparent power. These components should be used to determine the primary source of the non-sinusoidal mode formation during the proper selection of the filter devices. For this purpose the five ways of non-sinusoidal mode formation are detected and for each of them the mathematical model has been created. The dependences of the total apparent power components changing under the variation of non-sinusoidal ways are determined by means of the mathematical modeling. These dependences should be considered as the theoretical basis for the choosing and proving of the type and structure of the filter device as the part of the automated power quality control and improvement system and also for the tuning of the parameters of the existing filter devices to improve their performance.

show abstract

Energy-saving technologies at oilfield facilities

Ulyasheva

Ponomarev

2021

IOP Conf. Ser.: Earth Environ. Sci.

View full text Add to dashboard Cite

The article presents the results of the analysis of energy generation and consumption systems at the oil field facilities. The assessment of the state of the energy supply systems of the facility was carried out. The research presents the results of thermal imaging control of heat generation and transmission losses through the external fences of buildings. The generalized characteristics of the energy efficiency of the surveyed object are considered. The article analyses the directions of energy-saving, taking into account the peculiarities of the climatic features of the location of oil fields. The research justifies the relevance of using energy-saving technologies.

show abstract

Power Supply of Oil Production Facilities Using Associated Petroleum Gas

Cited by 5 publications

References 4 publications

Associated Petroleum Gas: Environmental, Utilization, and Economic Rationale

Associated Petroleum Gas: Environmental, Utilization, and Economic Rationale

The modeling and analysis of the parameters of the non-sinusoidal modes

Energy-saving technologies at oilfield facilities

Contact Info

Product

Resources

About