Pre-oxidation of Ti and its diffusion bonding to K9 glass: microstructure and mechanism properties

Chen, Min; Wang, Meirong; Yang, Haifeng; Wang, Xiongyao; Tang, Dewei; Jiang, Jiahao

doi:10.1007/s10853-022-06947-w

Cited by 3 publications

(1 citation statement)

References 26 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Various methods have been utilized for bonding glass and metal, including adhesive bonding, mechanical fixation, high-temperature sintering, and laser welding, among others [9,10]. Laser welding has emerged as a notable technique, garnering considerable attention due to its unique capability to deliver precise and localized heat for pattern bonding purposes.…”

Section: Introductionmentioning

confidence: 99%

Characterizations of Laser Transmission Welding of Glass and Copper Using Nanosecond Pulsed Laser

Nguyen,

Lin,

Tung

et al. 2023

Preprint

View full text Add to dashboard Cite

In this study, we conducted an investigation into the heterogeneous bonding process of glass and copper using a nanosecond pulsed laser for laser transmission welding. Our research focused on examining various processing parameters and the influence of focal plane positions on bonding quality. To evaluate weld strength, we employed both pull-tensile separation force (PTSF) and shear-tensile separation force (STSF) measurements. The analysis of fracture and separation results encompassed detailed examinations of weld morphology, microstructure, elemental composition, and phase configuration. The results revealed that increasing the laser welding energy initially enhanced the weld strength until it reached a saturation point. This saturation point was attributed to the formation of voids or cracks, leading to residual stress within the weld zone due to non-uniform hot spots in the molten area during processing. Among the different focal plane positions tested, positioning it below the glass/copper interface yielded the highest weld strength. The maximum achieved bond strength was above 10 MPa, demonstrating the feasibility of cost-effective pulsed laser welding for copper-to-glass applications. Furthermore, the welds exhibited superior resistance to STSF compared to PTSF. PTSF caused breaking at the weld seam-glass boundary, leaving the weld seam on the copper plate, whereas STSF resulted in separation along the weld-copper interface, leaving the weld seam on the glass sheet. In-depth analysis through SEM and EDS elucidated that Cu and SiO2 underwent intra-mixing and inter-particle diffusion in the molten pool during welding. HR-TEM and SAED observations unveiled the presence of polycrystalline copper nanoparticles, copper oxides, and an amorphous Cu-O-Si region at the weld interface. This amorphous region significantly contributed to the robust bonding between copper and glass.

show abstract

Section: Introductionmentioning

confidence: 99%