Prediction of crack opening in steel beam based on strains measured from distributed optical fiber sensor

Abstract

Optical fiber sensors based on the Brillouin optical time domain analysis (BOTDA) have good accuracy of crack opening displacement (COD) measurements. In this paper, we propose a method for COD quantification based on the area under the Brillouin frequency peaks induced by a crack. The study adopted a three-dimensional (3D) finite element model (FEM) to simulate the strain distribution within a segment of an optical fiber. The simulation results revealed that an increase in COD was associated with an increase in the Brillouin frequency peak area. The peak strain increased by 93 με when the COD increased from 30 μm to 110 μm. The numerical findings were proved experimentally by employing a BOTDA interrogator for distributed sensing of strains. Two cracks in a 15-m-long steel beam were detected with the smallest error of 13%. The COD was predicted from the areas under the crack-introduced strain peaks under varying loads of 97, 196, 294 and 392 N. The effect of different spatial resolutions (10, 20 and 50 cm) and intervals (1, 2.5 and 5 cm) on sensing performance was discussed. Compared to previous research, the 3D FEM not only accurately predicted the changes in distributed optical fibers with cracks but also simplified traditional theoretical analysis. For the first time, a method has been introduced to predict cracks by comparing the area under the Brillouin peaks. This approach not only enhanced linearity but also reduced errors. The proposed method can be easily implemented in engineering practice for multi-point crack sensing in civil infrastructure.

Strain Measurement Technology and Precision Calibration Experiment Based on Flexible Sensing Fiber

“…With the advantages of OFDR technology, it provides a new idea for the design of various sensing test schemes [ 11 , 12 ]. At present, with the development of FBG and OFDR, FBG and OFDR have been widely used in the measurement of temperature, strain, stress and other physical parameters [ 13 , 14 , 15 ]. As the basic application of optical fiber sensing technology, strain measurement, as a key index, needs further calibration and analysis.…”